EUVIMEDEUVIMED entdecken
Crossref

Modeling and Compensation of Multitilt Geometric Errors in a Four-Axis Aero-Engine Blade Measurement System

Jiaxun Sun, Chuanzhi Sun, Zhangqing Yin, Yu Sun, Xin Wang, Yongmeng Liu, Jiubin Tan

IEEE Transactions on Instrumentation and Measurement · 2026 · 75 · 1-12

DOI: 10.1109/tim.2026.3674270 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IEEE Transactions on Instrumentation and Measurement, 2026. Verfasst von Jiaxun Sun und 6 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Gefördert von: National Key Research and Development Program of China, National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The geometric accuracy of aero-engine blades is critical to engine performance and operational safety, imposing stringent requirements on blade profile measurement precision. This article presents a 3-D blade measurement system based on a four-axis platform equipped with a spectral confocal sensor. To model system-induced geometric deviations, a multitilt geometric error model (MT-GEM) is established to jointly account for guide-rail inclination errors, sensor installation errors, and rotary-axis deviations. The MT-GEM is solved in a two-stage manner: initial estimates of the guide-rail inclination parameters are first obtained via ellipsoid fitting combined with linear least-squares estimation, based on which the initial kinematic parameters of the rotary table, including the rotation axis and center, are derived. Subsequently, a joint nonlinear optimization is performed to refine all MT-GEM parameters. To enable efficient calibration with minimal artifacts, a three-parameter constrained sphere pair model (TPCSPM) is introduced, allowing system calibration using only a pair of standard spheres. Experimental results demonstrate that the proposed framework achieves robust and accurate parameter estimation and significantly reduces measurement deviations. After calibration, the radius error of a standard sphere is reduced to 0.018 mm, validating the effectiveness of the proposed method for high-precision, noncontact blade inspection.

Förderung

  • National Key Research and Development Program of China
  • National Natural Science Foundation of China

Zitieren

APA

Sun, J., Sun, C., Yin, Z., Sun, Y., Wang, X., Liu, Y., & Tan, J. (2026). Modeling and Compensation of Multitilt Geometric Errors in a Four-Axis Aero-Engine Blade Measurement System. IEEE Transactions on Instrumentation and Measurement, 75, 1-12. https://doi.org/10.1109/tim.2026.3674270

Vancouver

Sun J, Sun C, Yin Z, Sun Y, Wang X, Liu Y, et al. Modeling and Compensation of Multitilt Geometric Errors in a Four-Axis Aero-Engine Blade Measurement System. IEEE Transactions on Instrumentation and Measurement. 2026;75:1-12. doi:10.1109/tim.2026.3674270

BibTeX
@article{Sun2026,
  author = {Sun, Jiaxun and Sun, Chuanzhi and Yin, Zhangqing and Sun, Yu and Wang, Xin and Liu, Yongmeng and Tan, Jiubin},
  title = {Modeling and Compensation of Multitilt Geometric Errors in a Four-Axis Aero-Engine Blade Measurement System},
  journal = {IEEE Transactions on Instrumentation and Measurement},
  year = {2026},
  volume = {75},
  pages = {1--12},
  doi = {10.1109/tim.2026.3674270}
}
Kostenlos starten →