A 3-D-Printed Low-Cost War-Horn-Shaped Bidirectional Capacitive Wind Sensor
IEEE Sensors Journal · 2026-11 · 26 (21) · 32155-32162
DOI: 10.1109/jsen.2026.3732245 ↗Kurz gefasst
Fachartikel in der Zeitschrift IEEE Sensors Journal, 2026-11. Verfasst von Muhammet Rojhat Kara. Die Arbeit nennt 30 Literaturangaben. Gefördert von: Karamanoglu Mehmetbey University Scientific Research Projects Coordination Unit.
Abstract (Originalsprache)
This article introduces a low-cost, 3-D-printed bidirectional capacitive wind sensor in which a war-horn-shaped electrode linearizes the arcuate motion of a pendulum to enable bidirectional single-axis measurement with a single electrode pair, a transduction scheme that, to the best of the author’s knowledge, has not been previously reported. As wind deflects the pendulum, which is suspended from the air-duct ceiling by paper strips, the accompanying change in electrode overlap is converted into capacitance variations that are digitized by a capacitance-to-digital converter and relayed to a computer through an ARM-based microcontroller. Experimental evaluation demonstrates that the sensor provides stable and repeatable performance under both stepwise and instantaneous wind conditions up to ±15 m/s, with response and recovery times of 0.71 and 1 s, respectively. The device exhibits low hysteresis (4%) and nonlinearity (4.98%), attributed to the war-horn-shaped electrode that mitigates the effects of circular pendulum motion, maintaining near-linear output. Furthermore, the wind sensitivity is calculated to be 24.4 fF/(m/s), and the combined standard measurement uncertainty is estimated at 0.91 m/s. In addition to wind measurements, the sensor functions as a tilt sensor over a 0°–180° range, achieving a sensitivity of 2.03 fF/° while maintaining satisfactory stability. The fabrication process, based on additive manufacturing with polylactic acid (PLA), paper strips, and copper sheets, enables production at approximately ${\$}1$ per unit, emphasizing cost-effectiveness. The measurement range is readily scalable by adjusting the pendulum mass, and the dual-mode operation, covering both wind and inclination sensing, indicates strong potential for portable environmental monitoring.
Förderung
- Karamanoglu Mehmetbey University Scientific Research Projects Coordination Unit
Zitieren
APA
Kara, M. R. (2026). A 3-D-Printed Low-Cost War-Horn-Shaped Bidirectional Capacitive Wind Sensor. IEEE Sensors Journal, 26(21), 32155-32162. https://doi.org/10.1109/jsen.2026.3732245
Vancouver
Kara MR. A 3-D-Printed Low-Cost War-Horn-Shaped Bidirectional Capacitive Wind Sensor. IEEE Sensors Journal. 2026;26(21):32155-32162. doi:10.1109/jsen.2026.3732245
BibTeX
@article{Kara2026,
author = {Kara, Muhammet Rojhat},
title = {A 3-D-Printed Low-Cost War-Horn-Shaped Bidirectional Capacitive Wind Sensor},
journal = {IEEE Sensors Journal},
year = {2026},
volume = {26},
number = {21},
pages = {32155--32162},
doi = {10.1109/jsen.2026.3732245}
}
EUVIMED