EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Stress and springback adjustment in pressing forming of 316L stainless steel sheet using rigid-elastic compound die

Shiyu Wen, Xiao-Lei Cui, Shijian Yuan

Composite Design and Manufacturing · 02.06.2026 · 2 (2)

DOI: 10.1093/cdm/wqag012 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Composite Design and Manufacturing, online erschienen am 02.06.2026. Verfasst von Shiyu Wen und 2 weiteren Autor:innen. Die Arbeit nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objectives

Thin-walled components with large size and complex curved surface are extensively used in a multiplicity of fields. Due to their complex profile and the demand for high dimensional accuracy, traditional rigid die stamping processes are challenging for forming these components.

Methods

To solve this problem, a pressing forming process using a rigid-elastic compound die is proposed in this investigation, in which polyurethane elastomer was used to replace part of the rigid dies. This approach allows for nearly uniform loading on the sheet blank, enhancing its filling capacity towards the die. The deformation behaviour of 316L stainless steel sheet was investigated during the pressing process on a single-curvature die. On this basis, the effect of the rigid-elastic compound die on the springback behaviour of the sheet after pressing was analysed.

Results

In rigid die pressing with a 10 kN load, the maximum contact pressure on the sheet is 16.6 MPa, while it is 7.4 MPa in the rigid-elastic compound dies pressing. In the rigid-elastic compound die pressing with a 20 kN load, the profile height of the specimen exhibits springback by an average of 25% compared to the designed value, which decreases by 43% compared to that of the rigid die pressing. Furthermore, using local elastic compensation pads pressing, the specimen profile deviation can be controlled within 0.4 mm.

Conclusion

It is shown that the elastic die can apply a nearly uniform contact pressure on the sheet blank. This can improve the deformation uniformity of components and reduce the springback.

Förderung

  • National Natural Science Foundation of China

Zitieren

APA

Wen, S., Cui, X., & Yuan, S. (2026). Stress and springback adjustment in pressing forming of 316L stainless steel sheet using rigid-elastic compound die. Composite Design and Manufacturing, 2(2). https://doi.org/10.1093/cdm/wqag012

Vancouver

Wen S, Cui X, Yuan S. Stress and springback adjustment in pressing forming of 316L stainless steel sheet using rigid-elastic compound die. Composite Design and Manufacturing. 2026;2(2). doi:10.1093/cdm/wqag012

BibTeX
@article{Wen2026,
  author = {Wen, Shiyu and Cui, Xiao-Lei and Yuan, Shijian},
  title = {Stress and springback adjustment in pressing forming of 316L stainless steel sheet using rigid-elastic compound die},
  journal = {Composite Design and Manufacturing},
  year = {2026},
  volume = {2},
  number = {2},
  doi = {10.1093/cdm/wqag012}
}
Kostenlos starten →