Microstructure and mechanical properties of WS 2 -reinforced Cu–10Al–4Ni–1.5Si composites prepared via powder metallurgy
Physica Scripta · 20.03.2026 · 101 (11) · 115920
DOI: 10.1088/1402-4896/ae4f37 ↗Kurz gefasst
Fachartikel in der Zeitschrift Physica Scripta, online erschienen am 19.03.2026. Verfasst von Bo Li und 8 weiteren Autor:innen. Die Arbeit nennt 38 Literaturangaben. Gefördert von: Natural Science Foundation of Chongqing Municipality.
Abstract (Originalsprache)
This study investigates the effects of tungsten disulfide (WS 2 ) addition on the microstructure, mechanical properties, and tribological behavior of Cu–10Al–4Ni–1.5Si alloys fabricated via powder metallurgy. The samples were pressed at 570 MPa and sintered at 950 °C in an argon atmosphere for 60 min. Microstructural analysis via x-ray diffraction, scanning electron microscopy, energy-dispersive spectroscopy, and transmission electron microscopy revealed that the base alloy is primarily composed of α -Cu, Cu 9 Al 4 , and NiAl phases. However, the addition of WS 2 resulted in the formation of Cu 2 S compounds and the precipitation of hard tungsten particles. Notably, the W phase was present within locally clustered Cu 2 S areas. With an increase in the WS 2 content, the sintered density of the alloy increased from approximately 87.38% to 88.87% and then decreased. Hardness increased from approximately 136 to 143 HB and then decreased. Similarly, the tensile strength increased from approximately 397 to 433 MPa and then decreased. As the WS 2 content increased, the coefficient of friction of the alloy increased from approximately 0.28 to 0.32. However, the wear mass loss exhibited a complex fluctuation, initially increasing to 67.64 mg before reaching a localized minimum of 65.67 mg. These results provide a theoretical framework for optimizing high-performance Cu-Al-Ni powder alloys for industrial applications.
Förderung
- Natural Science Foundation of Chongqing Municipality
Zitieren
APA
Li, B., Deng, Z., Yang, Q., Liu, L., Shou, D., Gong, X., Zhang, C., Liu, H., & Xiao, Y. (2026). Microstructure and mechanical properties of WS 2 -reinforced Cu–10Al–4Ni–1.5Si composites prepared via powder metallurgy. Physica Scripta, 101(11), 115920. https://doi.org/10.1088/1402-4896/ae4f37
Vancouver
Li B, Deng Z, Yang Q, Liu L, Shou D, Gong X, et al. Microstructure and mechanical properties of WS 2 -reinforced Cu–10Al–4Ni–1.5Si composites prepared via powder metallurgy. Physica Scripta. 2026;101(11):115920. doi:10.1088/1402-4896/ae4f37
BibTeX
@article{Li2026,
author = {Li, Bo and Deng, Zhenghua and Yang, Qingfeng and Liu, Lizi and Shou, Derong and Gong, Xiaoxiang and Zhang, Chaoyang and Liu, Haili and Xiao, Yifei},
title = {Microstructure and mechanical properties of WS 2 -reinforced Cu–10Al–4Ni–1.5Si composites prepared via powder metallurgy},
journal = {Physica Scripta},
year = {2026},
volume = {101},
number = {11},
pages = {115920},
doi = {10.1088/1402-4896/ae4f37}
}
EUVIMED