EUVIMEDEUVIMED entdecken
Crossref

Three-dimensional printing as a rapid prototyping approach for novel radio frequency cavity designs

David Sims iD, Benjamin Sims, Brian Wright iD, John W Lewellen iD, Sergey V Baryshev

Review of Scientific Instruments · 01.07.2026 · 97 (7)

DOI: 10.1063/5.0315255 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Review of Scientific Instruments, online erschienen am 22.07.2026. Verfasst von David Sims und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Electrical and Computer Engineering, Michigan State University, East Lansing, Michigan 48824, USA. Die Arbeit nennt 15 Literaturangaben. Gefördert von: U.S. Department of Energy.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Three-dimensional (3D) printing of radio frequency (RF) cavity resonators could provide a cost-effective solution that enables rapid prototyping and design flexibility compared to traditional fabrication of full-metal cavities. In this work, the feasibility of fabrication of a useful multi-mode gigahertz (GHz) cavity is explored. Two kinds of plastics, two slicing approaches, and two metal coating techniques were used to build a series of clamped cavities with thin inner copper surface on otherwise 3D printed plastic surface. The cavities were then bench-tested to identify spatial field distributions, operating frequencies, and quality factor (Q-factor). Pros and cons of the used fabrication approaches were identified and understood, and the performance of longitudinally sliced painted cavity design demonstrated considerable practicality of the 3D-printing approach in designing RF systems.

Autor:innen und Institutionen

  • Department of Electrical and Computer Engineering, Michigan State University, East Lansing, Michigan 48824, USA.
  • Department of Physics and Astronomy, Michigan State University, East Lansing, Michigan 48824, USA.
  • Facility for Rare Isotope Beams, Michigan State University, East Lansing, Michigan 48824, USA.
  • Accelerator Operations and Technology Division, Los Alamos National Laboratory, Los Alamos, New Mexico 87545, USA.
  • Department of Chemical Engineering and Material Science, Michigan State University, East Lansing, Michigan 48824, USA.

ORCID-Profile: David Sims, Brian Wright, John W Lewellen

Förderung

  • U.S. Department of Energy

Zitieren

APA

Sims, D., Sims, B., Wright, B., Lewellen, J. W., & Baryshev, S. V. (2026). Three-dimensional printing as a rapid prototyping approach for novel radio frequency cavity designs. Review of Scientific Instruments, 97(7). https://doi.org/10.1063/5.0315255

Vancouver

Sims D, Sims B, Wright B, Lewellen JW, Baryshev SV. Three-dimensional printing as a rapid prototyping approach for novel radio frequency cavity designs. Review of Scientific Instruments. 2026;97(7). doi:10.1063/5.0315255

BibTeX
@article{Sims2026,
  author = {Sims, David and Sims, Benjamin and Wright, Brian and Lewellen, John W and Baryshev, Sergey V},
  title = {Three-dimensional printing as a rapid prototyping approach for novel radio frequency cavity designs},
  journal = {Review of Scientific Instruments},
  year = {2026},
  volume = {97},
  number = {7},
  doi = {10.1063/5.0315255}
}
Kostenlos starten →