EUVIMEDSkopri EUVIMED
Open access · CC BY 4.0

Detection of dynamic temperature modulation using a thermal scanning probe lithography (t-SPL) system

M Ryu iD, F Könemann iD, S Kamegaki iD, C van Nisselroy iD, K Buddha iD, E Cagin iD, J Morikawa iD

Review of Scientific Instruments · 2025-04-01 · 96 (4)

DOI: 10.1063/5.0245701 ↗

At a glance

Journal article in Review of Scientific Instruments, published online on 2025-04-08. Written by M Ryu and 6 co-authors. Institution: National Metrology Institute of Japan (NMIJ), National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba 305-8563, Japan. Cited 3 times so far (Crossref); 46 references. The full text is freely available (open access, CC BY 4.0). Funded by: Japan Science and Technology Agency, Japan Society for the Promotion of Science.

AstrattDettalji biblijografiċiCiteRelated studies

Abstract (original language)

Nanoscale measurements of thermophysical properties, based on detecting temperature responses to periodic heat stimulation, can be achieved using a localized heating point instead of a localized sensing point. However, the concept of determining localized thermophysical properties via nano-heating as an alternative to nano-sensing has not yet been validated. In this study, we demonstrate the measurement of thermal diffusivity within a nanoscale-confined volume using a thermal scanning probe lithography (t-SPL) system. The sharp tip of the t-SPL probe is employed to locally and periodically heat the sample, which is placed on a pre-fabricated micro-thermocouple. Using the temperature wave analysis method, the thermal diffusivity of the sample is inferred from the frequency-dependent phase shift in the temperature response of a thermocouple. This technique was applied to the microscale structure of a chemically amplified negative-tone photoresist (mr-DWL). We show that confining the heat source to a nanoscale point contact can achieve spatial resolution at the nanoscale (10–100 nm), offering an alternative approach to miniaturizing the detector sensor.

Authors and institutions

  • National Metrology Institute of Japan (NMIJ), National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba 305-8563, Japan.
  • Heidelberg Instruments Nano AG, 8048 Zürich, Switzerland.
  • School of Materials and Chemical Technology, Institute of Science Tokyo (Science Tokyo), Tokyo 152-8550, Japan.
  • Research Center for Autonomous Systems Materialogy (ASMat), Institute of Integrated Research (IIR), Institute of Science Tokyo (Science Tokyo), Yokohama, Japan.

ORCID profiles: M Ryu, F Könemann, S Kamegaki, C van Nisselroy, K Buddha, E Cagin, J Morikawa

Funding

  • Japan Science and Technology Agency
  • Japan Society for the Promotion of Science

Cite

APA

Ryu, M., Könemann, F., Kamegaki, S., van Nisselroy, C., Buddha, K., Cagin, E., & Morikawa, J. (2025). Detection of dynamic temperature modulation using a thermal scanning probe lithography (t-SPL) system. Review of Scientific Instruments, 96(4). https://doi.org/10.1063/5.0245701

Vancouver

Ryu M, Könemann F, Kamegaki S, van Nisselroy C, Buddha K, Cagin E, et al. Detection of dynamic temperature modulation using a thermal scanning probe lithography (t-SPL) system. Review of Scientific Instruments. 2025;96(4). doi:10.1063/5.0245701

BibTeX
@article{Ryu2025,
  author = {Ryu, M and Könemann, F and Kamegaki, S and van Nisselroy, C and Buddha, K and Cagin, E and Morikawa, J},
  title = {Detection of dynamic temperature modulation using a thermal scanning probe lithography (t-SPL) system},
  journal = {Review of Scientific Instruments},
  year = {2025},
  volume = {96},
  number = {4},
  doi = {10.1063/5.0245701}
}
Start for free →