3D Printing of Thermally Responsive Shape Memory Liquid Crystalline Epoxy Networks
ACS Omega · 01.10.2024 · 9 (39) · 40801-40809
DOI: 10.1021/acsomega.4c05664 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Omega, online erschienen am 17.09.2024. Verfasst von Collin Pekol und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Materials Science and Engineering, The University of Tennessee, Knoxville, Tennessee 37996-4519, United States. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Division of Materials Research, , National Institute of Food and Agriculture, University of Tennessee.
Abstract (Originalsprache)
A two-component liquid crystalline epoxy network (LCEN) with shape memory behavior was developed and evaluated as a candidate material for 3D printing. The cure kinetics of the uncured material and the shape memory properties of the cured LCEN were investigated by using parallel plate rheology and dynamic mechanical analysis, respectively. A commercially available fumed silica additive was introduced to the neat, uncured material to improve the rheological properties for 3D printing. The addition of fumed silica was found to increase the yield stress, shear-thinning behavior, and toughness of the uncured epoxy ink. Polarized light microscopy, differential scanning calorimetry, and wide-angle X-ray scattering measurements between the neat and additive-modified LCEN suggested a reduction in liquid crystalline alignment in the modified LCEN, owing to interactions between crystalline domains and fumed silica, which in turn influenced the mechanical behavior. Overall, the additive was found to be successful in preserving the shape memory properties of LCEN while improving its printability.
Autor:innen und Institutionen
- Department of Materials Science and Engineering, The University of Tennessee, Knoxville, Tennessee 37996-4519, United States.
- School of Materials Science and Engineering, University of Science and Technology, Beijing 100083, China.
- Spallation Neutron Source, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37830, United States.
- Center for Renewable Carbon, University of Tennessee, Knoxville, Tennessee 37996-4570, United States.
ORCID-Profile: Collin Pekol, Yuzhan Li, David P Harper
Förderung
- Division of Materials Research
- , National Institute of Food and Agriculture
- University of Tennessee
Zitieren
APA
Pekol, C., Furst, J., Li, Y., Keum, J., & Harper, D. P. (2024). 3D Printing of Thermally Responsive Shape Memory Liquid Crystalline Epoxy Networks. ACS Omega, 9(39), 40801-40809. https://doi.org/10.1021/acsomega.4c05664
Vancouver
Pekol C, Furst J, Li Y, Keum J, Harper DP. 3D Printing of Thermally Responsive Shape Memory Liquid Crystalline Epoxy Networks. ACS Omega. 2024;9(39):40801-40809. doi:10.1021/acsomega.4c05664
BibTeX
@article{Pekol2024,
author = {Pekol, Collin and Furst, Jacob and Li, Yuzhan and Keum, Jong and Harper, David P},
title = {3D Printing of Thermally Responsive Shape Memory Liquid Crystalline Epoxy Networks},
journal = {ACS Omega},
year = {2024},
volume = {9},
number = {39},
pages = {40801--40809},
doi = {10.1021/acsomega.4c05664}
}
EUVIMED