EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Electrochemical Detection of Pseudomonas aeruginosa Quorum Sensing Molecule ( S )- N -Butyryl Homoserine Lactone Using Molecularly Imprinted Polymers

Margaux Frigoli iD, Joseph W Lowdon, Nicolas Donetti, Robert D Crapnell, Craig E Banks iD, Thomas J Cleij iD, Hanne Diliën, Kasper Eersels iD, Bart van Grinsven iD

ACS Omega · 14.08.2024

DOI: 10.1021/acsomega.4c03970 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Omega, online erschienen am 14.08.2024. Verfasst von Margaux Frigoli und 8 weiteren Autor:innen. Beteiligte Einrichtung: Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, P.O. Box 616, Maastricht 6200 MD, The Netherlands. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 65 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Interreg Vlaanderen-Nederland.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Pseudomonas aeruginosa is a multidrug-resistant Gram-negative bacterium that poses a significant threat to public health, necessitating rapid and on-site detection methods for rapid recognition. The goal of the project is therefore to indirectly detect the presence of P. aeruginosa in environmental water samples targeting one of its quorum-sensing molecules, namely, (S)-N-butyryl homoserine lactone (BHL). To this aim, molecularly imprinted polymers (MIPs) were synthesized via bulk free-radical polymerization using BHL as a template molecule. The obtained MIP particles were immobilized onto screen-printed electrodes (MIP-SPEs), and the BHL rebinding was analyzed via electrochemical impedance spectroscopy (EIS). To study the specificity of the synthesized MIPs, isotherm curves were built after on-point rebinding analysis performed via LC-MS measurements for both MIPs and NIPs (nonimprinted polymers, used as a negative control), obtaining an imprinting factor (IF) of 2.8 (at C f = 0.4 mM). The MIP-SPEs were integrated into an electrochemical biosensor with a linear range of 1 × 101-1 × 103 nM and a limit of detection (LoD) of 31.78 ± 4.08 nM. Selectivity measurements were also performed after choosing specific interferent molecules, such as structural analogs and potential interferents, followed by on-point analysis performed in spiked tap water to prove the sensor's potential to detect the presence of the quorum-sensing molecule in environmentally related real-life samples.

Autor:innen und Institutionen

  • Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, P.O. Box 616, Maastricht 6200 MD, The Netherlands.
  • John Dalton Building, Faculty of Science and Engineering, Manchester Metropolitan University, Chester Street, Manchester M1 5GD, U.K.

ORCID-Profile: Margaux Frigoli, Craig E Banks, Thomas J Cleij, Kasper Eersels, Bart van Grinsven

Förderung

  • Interreg Vlaanderen-Nederland

Zitieren

APA

Frigoli, M., Lowdon, J. W., Donetti, N., Crapnell, R. D., Banks, C. E., Cleij, T. J., Diliën, H., Eersels, K., & van Grinsven, B. (2024). Electrochemical Detection of Pseudomonas aeruginosa Quorum Sensing Molecule ( S )- N -Butyryl Homoserine Lactone Using Molecularly Imprinted Polymers. ACS Omega. https://doi.org/10.1021/acsomega.4c03970

Vancouver

Frigoli M, Lowdon JW, Donetti N, Crapnell RD, Banks CE, Cleij TJ, et al. Electrochemical Detection of Pseudomonas aeruginosa Quorum Sensing Molecule ( S )- N -Butyryl Homoserine Lactone Using Molecularly Imprinted Polymers. ACS Omega. 2024. doi:10.1021/acsomega.4c03970

BibTeX
@article{Frigoli2024,
  author = {Frigoli, Margaux and Lowdon, Joseph W and Donetti, Nicolas and Crapnell, Robert D and Banks, Craig E and Cleij, Thomas J and Diliën, Hanne and Eersels, Kasper and van Grinsven, Bart},
  title = {Electrochemical Detection of Pseudomonas aeruginosa Quorum Sensing Molecule ( S )- N -Butyryl Homoserine Lactone Using Molecularly Imprinted Polymers},
  journal = {ACS Omega},
  year = {2024},
  doi = {10.1021/acsomega.4c03970}
}
Kostenlos starten →