Treatment of fine and medium fractions of MSWI bottom ash for use in concrete: A German case study
Waste Management · 2025
DOI: 10.1016/j.wasman.2025.02.050 ↗Kurz gefasst
Fachartikel in der Zeitschrift Waste Management, 2025. Verfasst von Iveta Vateva und 3 weiteren Autor:innen. Beteiligte Einrichtung: Research Center for Resource Management and Solid Waste Engineering, Faculty of Civil and Environmental Engineering, University of Kassel, Möncheberg…. Hauptthemen laut MEDLINE: Construction Materials, Incineration, Coal Ash. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 61 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: German Federal Environmental Foundation.
Abstract (Originalsprache)
Incineration bottom ash (IBA) is the main solid residue from municipal solid waste incineration. IBA mostly contains minerals that can be used as secondary construction materials in unbound applications as well as concrete after appropriate treatment. Major challenges, in particular for its utilization in concrete, are residual metal contents, soluble salts, as well as the high porosity of the material. The goal of this study was to investigate the processing of the fine (0-2 mm) and medium (2-8 mm) IBA fractions with respect to their utilization as a partial substitute for binder and aggregates in concrete. Therefore, the IBA was treated in a two-stage process and the material fractions produced were utilized as secondary aggregates and partial cement replacement in concrete paving stones. The processing led to a reduction in residual metal concentrations, e.g. the metallic aluminum was reduced by 67 % and 60 % in the processed fine and medium fractions, respectively. Soluble metals and salts could be reduced to some extent, but remaining salts (up to 1800 mg/l and 2300 mg/l for chloride and sulfate, respectively) hinder the use of the IBA in reinforced concrete. The results demonstrate that IBA has promising potential for use in concrete paving stones, but further optimization is needed to meet requirements such as tensile splitting strength and weathering resistance (the tensile splitting strength was approx. 20 % lower and the frost resistance was about 4 times higher). Overall, partial replacement of binder and aggregates can effectively contribute to reducing the environmental footprint of concrete products.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Substanzen
Autor:innen und Institutionen
- Research Center for Resource Management and Solid Waste Engineering, Faculty of Civil and Environmental Engineering, University of Kassel, Mönchebergstraße 7, Kassel 34125, Germany. Electronic address: iveta.vateva@uni-…
- Department of Structural Materials and Construction Chemistry, Faculty of Civil and Environmental Engineering, University of Kassel, Mönchebergstraße 7, Kassel 34125, Germany.
- Research Center for Resource Management and Solid Waste Engineering, Faculty of Civil and Environmental Engineering, University of Kassel, Mönchebergstraße 7, Kassel 34125, Germany.
Förderung
- German Federal Environmental Foundation
Zitieren
APA
Vateva, I., Laabs, M., Middendorf, B., & Laner, D. (2025). Treatment of fine and medium fractions of MSWI bottom ash for use in concrete: A German case study. Waste Management. https://doi.org/10.1016/j.wasman.2025.02.050
Vancouver
Vateva I, Laabs M, Middendorf B, Laner D. Treatment of fine and medium fractions of MSWI bottom ash for use in concrete: A German case study. Waste Management. 2025. doi:10.1016/j.wasman.2025.02.050
BibTeX
@article{Vateva2025,
author = {Vateva, Iveta and Laabs, Marcel and Middendorf, Bernhard and Laner, David},
title = {Treatment of fine and medium fractions of MSWI bottom ash for use in concrete: A German case study},
journal = {Waste Management},
year = {2025},
doi = {10.1016/j.wasman.2025.02.050}
}
EUVIMED