Reinforcement methods and environmental assessment of sustainable cold-bonded artificial aggregates prepared from municipal solid waste incineration bottom ash
Environmental Research · 2026
DOI: 10.1016/j.envres.2026.125751 ↗Kurz gefasst
Fachartikel in der Zeitschrift Environmental Research, 2026. Verfasst von Weizhuo Zhang und 9 weiteren Autor:innen. Beteiligte Einrichtung: College of Civil Engineering and Transportation, Guangzhou University, Guangzhou, 510006, PR China; Guangdong Provincial Key Laboratory of Durability…. Hauptthemen laut MEDLINE: Incineration, Solid Waste, Construction Materials, Coal Ash. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 58 Literaturangaben. Gefördert von: Guangdong Provincial Key Laboratory of Durability for Marine Civil Engineering, Basic and Applied Basic Research Foundation of Guangdong Province, Shenzhen Science and Technology Innovation Program.
Abstract (Originalsprache)
Limestone calcined clay cement (LC3) and municipal solid waste incineration bottom ash (MSWIBA) were used to produce cold-bonded artificial aggregates, integrating the use of a low-clinker binder with solid-waste resource recovery. Three groups of LC3-MSWIBA artificial aggregates (LMAA) mixtures were prepared, and eleven curing regimes were adopted, including steam and water curing at 20-80 °C, water curing, sealed curing, carbonation curing and natural curing. Their physical properties, single-particle compressive strength, phase assemblage, microstructure, and heavy-metal leaching behavior were systematically characterized; the compressive strength of LMAA concrete and direct production costs were also evaluated. At the same curing temperature, water-cured LMAA generally outperformed steam-cured LMAA. Peak compressive strength were generally obtained at 40-60 °C, with a maximum 28 d value exceeding 3.5 MPa. Sealed curing produced performance comparable to the high-humidity 20 °C reference, whereas natural curing offered no clear advantage. X-ray diffraction (XRD), thermogravimetric analysis (TGA), and scanning electron microscopy (SEM) indicated that differences among curing regimes were mainly associated with the degree of hydration, carbonate-bearing phases, and pore structure. Under the TCLP extraction conditions used in this study, the measured heavy-metal concentrations in the leachates were below the applicable regulatory limits. At a 50% volume replacement of natural coarse aggregate, concrete containing L50M70 showed only a 0.4% reduction in 28 d compressive strength relative to the natural-aggregate control, whereas the reduction increased to 21.7% at 100% volume replacement. Among the conditions examined and under the baseline economic assumptions adopted in this study, L50M70 subjected to 40 °C water curing provided the most favorable balance among aggregate performance, MSWIBA utilization, concrete compatibility, and direct curing cost.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- College of Civil Engineering and Transportation, Guangzhou University, Guangzhou, 510006, PR China; Guangdong Provincial Key Laboratory of Durability for Marine Civil Engineering, College of Civil and Transportation Eng…
- Guangdong Provincial Key Laboratory of Durability for Marine Civil Engineering, College of Civil and Transportation Engineering, Shenzhen University, Shenzhen, 518060, PR China.
- Guangdong Provincial Key Laboratory of Durability for Marine Civil Engineering, College of Civil and Transportation Engineering, Shenzhen University, Shenzhen, 518060, PR China. Electronic address: 2100471074@email.szu.…
- Guangdong Provincial Key Laboratory of Durability for Marine Civil Engineering, College of Civil and Transportation Engineering, Shenzhen University, Shenzhen, 518060, PR China; State Key Laboratory of Intelligent Const…
- College of Civil Engineering and Transportation, Guangzhou University, Guangzhou, 510006, PR China.
- China Energy Engineering Group Hunan Electric Power Design Institute Co., LTD, Changsha, 410007, PR China.
Förderung
- Guangdong Provincial Key Laboratory of Durability for Marine Civil Engineering
- Basic and Applied Basic Research Foundation of Guangdong Province
- Shenzhen Science and Technology Innovation Program
Zitieren
APA
Zhang, W., Niu, R., Hu, J., Zhou, L., Wang, Z., Cheng, L., Xie, G., Wu, X., Liu, Z., & Liu, J. (2026). Reinforcement methods and environmental assessment of sustainable cold-bonded artificial aggregates prepared from municipal solid waste incineration bottom ash. Environmental Research. https://doi.org/10.1016/j.envres.2026.125751
Vancouver
Zhang W, Niu R, Hu J, Zhou L, Wang Z, Cheng L, et al. Reinforcement methods and environmental assessment of sustainable cold-bonded artificial aggregates prepared from municipal solid waste incineration bottom ash. Environmental Research. 2026. doi:10.1016/j.envres.2026.125751
BibTeX
@article{Zhang2026,
author = {Zhang, Weizhuo and Niu, Renjie and Hu, Junjie and Zhou, Lantian and Wang, Zhengdong and Cheng, Lei and Xie, Guangming and Wu, Xingpei and Liu, Zhichen and Liu, Jun},
title = {Reinforcement methods and environmental assessment of sustainable cold-bonded artificial aggregates prepared from municipal solid waste incineration bottom ash},
journal = {Environmental Research},
year = {2026},
doi = {10.1016/j.envres.2026.125751}
}
EUVIMED