EUVIMEDEUVIMED entdecken
Crossref

Recovery and recycling of silica fabric from waste printed circuit boards to develop epoxy composite for electrical and thermal insulation applications

E I Anjana, K Aiswariya, K P Prathish, Sushanta K Sahoo, K Jayasankar

Waste Management · 2025

DOI: 10.1016/j.wasman.2025.02.017 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Waste Management, 2025. Verfasst von E I Anjana und 4 weiteren Autor:innen. Beteiligte Einrichtung: Materials Science & Technology Division, CSIR-National Institute for Interdisciplinary Science and Technology, Thiruvananthapuram 695019, India; Acad…. Hauptthemen laut MEDLINE: Recycling, Electronic Waste, Silicon Dioxide, Epoxy Resins. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 54 Literaturangaben. Gefördert von: Department of Science and Technology, Ministry of Science and Technology, India.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Printed Circuit Boards (PCBs), a primary component of electronic waste (E-waste), contain silica fabric as a major non-metallic material, which needs to be reutilized for high-performance applications. This study focuses on the separation and recovery of silica fabrics through pyrolysis and their subsequent use in developing silica fabric-epoxy composites (SFR). Extracted silica fabric was characterized through FTIR, XRD, XPS, and SEM for morphology analysis. Subsequently, silica fabric was incorporated into epoxy to fabricate a composite with different compositions through a hand lay-up technique to achieve enhanced mechanical, thermal, and dielectric properties. The interface morphology, dielectric constant, mechanical strength, thermal conductivity, and thermal stability of composites were investigated. A strong-fabric matrix interface in composite was observed through micrographs, revealing the stress transfer through the fabric. The composition of silica fabric: epoxy (70:30) showed a high electrical resistance >30000 Ω/m, a high dielectric constant value (ɛr) of 4-5, and ultimate tensile strength (UTS) of 105 MPa. The thermal conductivity of epoxy was reduced from 0.35 to 0.15 W/m K after incorporating the silica fabric. This study introduces a novel method for recycling electronic waste, specifically focusing on PCBs to extract silica fabric (>95 %) through low-temperature pyrolysis (600 ⁰C) to create high-performance silica fabric-epoxy (SFR) composites. These SFR composites are suitable for several applications, including structural components and industry insulation materials such as battery boxes. This sustainable approach addresses e-waste management and enhances composite material performance, highlighting SFR epoxy composites' versatility and research potential in various applications.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

RecyclingElectronic WasteSilicon DioxideEpoxy ResinsThermal ConductivityTensile StrengthPyrolysis

Stichwörter der Autor:innen

Electrical InsulationEpoxy compositePrinted Circuit BoardsSilica FabricWaste management

Substanzen

Silicon DioxideEpoxy Resins

Autor:innen und Institutionen

  • Materials Science & Technology Division, CSIR-National Institute for Interdisciplinary Science and Technology, Thiruvananthapuram 695019, India; Academy of Scientific and Innovative Research (AcSIR), Ghaziabad 201002, I…
  • Materials Science & Technology Division, CSIR-National Institute for Interdisciplinary Science and Technology, Thiruvananthapuram 695019, India. Electronic address: aiswariyaknair@gmail.com.
  • Environmental Technology Division, CSIR-National Institute for Interdisciplinary Science and Technology, Thiruvananthapuram 695019, India; Academy of Scientific and Innovative Research (AcSIR), Ghaziabad 201002, India.…

Förderung

  • Department of Science and Technology, Ministry of Science and Technology, India

Zitieren

APA

Anjana, E. I., Aiswariya, K., Prathish, K. P., Sahoo, S. K., & Jayasankar, K. (2025). Recovery and recycling of silica fabric from waste printed circuit boards to develop epoxy composite for electrical and thermal insulation applications. Waste Management. https://doi.org/10.1016/j.wasman.2025.02.017

Vancouver

Anjana EI, Aiswariya K, Prathish KP, Sahoo SK, Jayasankar K. Recovery and recycling of silica fabric from waste printed circuit boards to develop epoxy composite for electrical and thermal insulation applications. Waste Management. 2025. doi:10.1016/j.wasman.2025.02.017

BibTeX
@article{Anjana2025,
  author = {Anjana, E I and Aiswariya, K and Prathish, K P and Sahoo, Sushanta K and Jayasankar, K},
  title = {Recovery and recycling of silica fabric from waste printed circuit boards to develop epoxy composite for electrical and thermal insulation applications},
  journal = {Waste Management},
  year = {2025},
  doi = {10.1016/j.wasman.2025.02.017}
}
Kostenlos starten →