EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Polyetherimide in 3D printing: Pioneering non-metallic solutions for personalized orthopedic and traumatology hip prosthetics

M. Suffo, C. López-Marín, C. Revenga, P. Andrés-Cano

Results in Engineering · 2024-09 · 23 · 102372

DOI: 10.1016/j.rineng.2024.102372 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Results in Engineering, 2024-09. Verfasst von M. Suffo und 3 weiteren Autor:innen. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Junta de Andalucía.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Currently, Total Hip Replacement (THR) hip prosthetics are typically made from metallic materials using subtractive manufacturing, and they are not personalized. These materials, with higher densities than trabecular bone, can cause microfractures due to fatigue cycles. This study aims to demonstrate the feasibility of using Polyetherimide (PEI) as a rigid thermoplastic in additive manufacturing, offering a viable alternative for patient-specific prostheses in humans or pets. The starting point was a commercial prosthesis, a similar replica was 3D modelled, and test specimens were printed using ULTEM 1010 material. The PEI prosthesis meets outlined standards and offers an alternative for young, lightweight patients, and various pets. It does so by adapting to specific the patient's anatomical needs. Fatigue life was found to be the limiting factor, as the 392 N applied prosthesis, exceeded the million cycles limitation set for this study, prompting us to focus on the prosthesis' use on children, or small pets.

Förderung

  • Junta de Andalucía

Zitieren

APA

Suffo, M., López-Marín, C., Revenga, C., & Andrés-Cano, P. (2024). Polyetherimide in 3D printing: Pioneering non-metallic solutions for personalized orthopedic and traumatology hip prosthetics. Results in Engineering, 23, 102372. https://doi.org/10.1016/j.rineng.2024.102372

Vancouver

Suffo M, López-Marín C, Revenga C, Andrés-Cano P. Polyetherimide in 3D printing: Pioneering non-metallic solutions for personalized orthopedic and traumatology hip prosthetics. Results in Engineering. 2024;23:102372. doi:10.1016/j.rineng.2024.102372

BibTeX
@article{Suffo2024,
  author = {Suffo, M. and López-Marín, C. and Revenga, C. and Andrés-Cano, P.},
  title = {Polyetherimide in 3D printing: Pioneering non-metallic solutions for personalized orthopedic and traumatology hip prosthetics},
  journal = {Results in Engineering},
  year = {2024},
  volume = {23},
  pages = {102372},
  doi = {10.1016/j.rineng.2024.102372}
}
Kostenlos starten →