EUVIMEDEUVIMED entdecken
Crossref

Effect of different preparations and restorative materials on partial posterior restorations: A 3D FEA study using μCT data

Cibele Cândida de Almeida Kintopp, Alysson Nunes Diógenes, Ricardo Tadeu Lopes, Katia Raquel Weber, Carlos Eduardo Edwards Rezende, Marina da Rosa Kaizer, Carla Castiglia Gonzaga

The Journal of Prosthetic Dentistry · 2025

DOI: 10.1016/j.prosdent.2025.01.011 ↗

Kurz gefasst

Fachartikel in der Zeitschrift The Journal of Prosthetic Dentistry, 2025. Verfasst von Cibele Cândida de Almeida Kintopp und 6 weiteren Autor:innen. Beteiligte Einrichtung: PhD student, School of Health Sciences, Graduate Program in Dentistry, Positivo University (UP), Curitiba, PR, Brazil. Hauptthemen laut MEDLINE: X-Ray Microtomography, Dental Materials, Dental Restoration, Permanent, Imaging, Three-Dimensional. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 32 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

STATEMENT OF PROBLEM: Three-dimensional finite element analysis (3D FEA) allows for the accurate simulation of stress distribution and identification of potential failures in posterior indirect restorations. By combining microcomputed tomography (μCT) with FEA, more realistic and reliable models can be created, improving the accuracy of predictions. PURPOSE: The purpose of this 3D FEA study using μCT data was to assess the effect of different restorative materials on stress distribution in partial posterior restorations and the resin cement layer. MATERIAL AND METHODS: Four replicas of a mandibular first molar were prepared for different partial posterior preparations: inlay, onlay, 1-piece endodontic crown, and occlusal veneer. For each model, monolithic posterior restorations were simulated with 4 different restorative materials: composite resin, lithium disilicate glass-ceramic, polymer-infiltrated ceramic, and zirconia. After the fabrication and luting of the restorations, μCT images of the specimens were obtained and 3D finite element models built. An evenly distributed load of 500 N was applied, simulating 3 occlusal contacts. The maximum value of maximum principal stress and stress distribution on the restorations, cement layers, and tooth structure was calculated and analyzed. RESULTS: One-piece endodontic crowns had lower stress, whereas inlays showed higher stress. Of the restorative materials, zirconia and glass-ceramic had the highest stress on the restorations, followed by polymer-infiltrated ceramic and composite resin. This difference between the restorative materials was larger for inlays and 1-piece endodontic crowns than for onlays and occlusal veneers. Cuspal coverage in the onlay preparation had lower and more evenly distributed stress than the intracoronal inlay preparation. CONCLUSIONS: The different tooth preparations for single-unit posterior partial restorations influenced the stress distribution on the restoration, resin cement layer, and remaining tooth structure.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

X-Ray MicrotomographyDental MaterialsDental Restoration, PermanentImaging, Three-DimensionalFinite Element AnalysisHumansComposite ResinsMolarCrownsCeramicsDental Stress AnalysisZirconiumInlaysDental VeneersDental PorcelainResin Cements

Substanzen

Dental MaterialsComposite Resinslithia disilicateZirconiumDental PorcelainResin Cementszirconium oxideGlass ceramics

Autor:innen und Institutionen

  • PhD student, School of Health Sciences, Graduate Program in Dentistry, Positivo University (UP), Curitiba, PR, Brazil.
  • Professor, Department of Mechanical Engineering, Positivo University (UP), Curitiba, PR, Brazil.
  • Researcher, Nuclear Engineering Program, Federal University of Rio de Janeiro (UFRJ), Rio de Janeiro, RJ, Brazil.
  • Postdoctoral Fellow, School of Health Sciences, Graduate Program in Dentistry, Positivo University (UP), Curitiba, PR, Brazil.
  • Professor, School of Health Sciences, Graduate Program in Dentistry, Positivo University (UP), Curitiba, PR, Brazil.
  • Professor, School of Health Sciences, Graduate Program in Dentistry, Positivo University (UP), Curitiba, PR, Brazil. Electronic address: carlacgonzaga2@gmail.com.

Zitieren

APA

Kintopp, C. C. A., Diógenes, A. N., Lopes, R. T., Weber, K. R., Rezende, C. E. E., Kaizer, M. D. R., & Gonzaga, C. C. (2025). Effect of different preparations and restorative materials on partial posterior restorations: A 3D FEA study using μCT data. The Journal of Prosthetic Dentistry. https://doi.org/10.1016/j.prosdent.2025.01.011

Vancouver

Kintopp CCA, Diógenes AN, Lopes RT, Weber KR, Rezende CEE, Kaizer MDR, et al. Effect of different preparations and restorative materials on partial posterior restorations: A 3D FEA study using μCT data. The Journal of Prosthetic Dentistry. 2025. doi:10.1016/j.prosdent.2025.01.011

BibTeX
@article{Kintopp2025,
  author = {Kintopp, Cibele Cândida de Almeida and Diógenes, Alysson Nunes and Lopes, Ricardo Tadeu and Weber, Katia Raquel and Rezende, Carlos Eduardo Edwards and Kaizer, Marina da Rosa and Gonzaga, Carla Castiglia},
  title = {Effect of different preparations and restorative materials on partial posterior restorations: A 3D FEA study using μCT data},
  journal = {The Journal of Prosthetic Dentistry},
  year = {2025},
  doi = {10.1016/j.prosdent.2025.01.011}
}
Kostenlos starten →