Achieving an improved performance in double-sided friction stir weld joints by adjusting the welding conditions during the passes of AA6061-T6 aluminium alloy
Micron · 2024-02 · 177 · 103563
DOI: 10.1016/j.micron.2023.103563 ↗Kurz gefasst
Fachartikel in der Zeitschrift Micron, 2024-02. Verfasst von Ankit Thakur und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Industrial and Production engineering, Dr. B.R. Ambedkar National Institute of Technology, Jalandhar, Punjab, India. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 42 Literaturangaben.
Abstract (Originalsprache)
The present study aims at investigating the effect of interaction between the process parameters of each weld pass (1st pass and 2nd pass) to improve the joint performance during the double-sided friction stir welded joints of AA6061-T6 aluminium alloy. Experimental designs were conducted following a design matrix developed using response surface methodology to investigate the impact on the microstructural changes and tensile properties. Pronounced interaction between the process parameters of each weld pass of the joint was observed and indicated a strong interdependency between them. The detailed microstructural study conducted through EBSD insights into the extent of homogenization, and abnormal grain refinement and reflects a vast transformation of low-angle grain boundaries into high-angle grain boundaries within the stir zone. The profound examination through scanning electron microscopy and transmission electron microscopy analysis validated the uniform homogeneous distribution of Al-Fe and Al-Si-rich precipitates. The significant improvement in the grain refinement and distribution of the strengthening precipitates within the stir zone led to a substantial enhancement in the microhardness, along with achieving a maximum ultimate tensile strength of 223 MPa and a percentage elongation of 14%. A study of the fracture morphology ensures the ductile fracture behavior of the tensile fracture specimen by observing the presence of numerous dimples within a well-bonded joint.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Industrial and Production engineering, Dr. B.R. Ambedkar National Institute of Technology, Jalandhar, Punjab, India.
- Department of Industrial and Production engineering, Dr. B.R. Ambedkar National Institute of Technology, Jalandhar, Punjab, India. Electronic address: sharmav@nitj.ac.in.
Zitieren
APA
Thakur, A., Sharma, V., Minhas, N., & Verma, R. (2024). Achieving an improved performance in double-sided friction stir weld joints by adjusting the welding conditions during the passes of AA6061-T6 aluminium alloy. Micron, 177, 103563. https://doi.org/10.1016/j.micron.2023.103563
Vancouver
Thakur A, Sharma V, Minhas N, Verma R. Achieving an improved performance in double-sided friction stir weld joints by adjusting the welding conditions during the passes of AA6061-T6 aluminium alloy. Micron. 2024;177:103563. doi:10.1016/j.micron.2023.103563
BibTeX
@article{Thakur2024,
author = {Thakur, Ankit and Sharma, Varun and Minhas, Navdeep and Verma, Rajeev},
title = {Achieving an improved performance in double-sided friction stir weld joints by adjusting the welding conditions during the passes of AA6061-T6 aluminium alloy},
journal = {Micron},
year = {2024},
volume = {177},
pages = {103563},
doi = {10.1016/j.micron.2023.103563}
}
EUVIMED