EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Geometrical control of eddy currents in additively manufactured Fe-Si

Alexander D. Goodall, Georgios Yiannakou, Lova Chechik, Ria L. Mitchell, Geraint W Jewell, Iain Todd

Materials & Design · 2023-06 · 230 · 112002

DOI: 10.1016/j.matdes.2023.112002 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials & Design, 2023-06. Verfasst von Alexander D. Goodall und 5 weiteren Autor:innen. Die Arbeit wurde bisher 27-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Henry Royce Institute, Engineering and Physical Sciences Research Council, University of Sheffield.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive manufacturing has enabled the processing of high silicon electrical steels which have excellent soft magnetic properties. In bulk form, core losses as a result of eddy currents would be too large to allow their use in high-frequency electrical machines, therefore strategies are needed to reduce eddy currents. Additive manufacturing affords high part complexity and provides the opportunity for cross sectional patterns within the material to limit eddy current generation. This study investigates several designs, including a novel hexagonal pattern which is shown to have the lowest eddy current loss coefficient of 0.0005, less than 25% of the bulk material which has an eddy current loss coefficient of 0.0021. Heat treatment is shown to increase the eddy current losses, demonstrating that for high-frequency machines, it may be beneficial to use the material in the as-built state. Physical samples were compared to their intended geometries, showing there are defects in these complex cross sections causing increased eddy currents when compared to simulations, but that geometrical accuracy can be improved by alternative design methodology which experimentally experiences smaller losses. These novel cross sectional designs may be implemented into an electric machine that has a 3D magnetic flux pathway enabled by additive manufacturing, affording more flexibility for electrical engineers to design new motor architectures in the pursuit of higher power density machines.

Förderung

  • Henry Royce Institute
  • Engineering and Physical Sciences Research Council
  • University of Sheffield

Zitieren

APA

Goodall, A. D., Yiannakou, G., Chechik, L., Mitchell, R. L., Jewell, G. W., & Todd, I. (2023). Geometrical control of eddy currents in additively manufactured Fe-Si. Materials & Design, 230, 112002. https://doi.org/10.1016/j.matdes.2023.112002

Vancouver

Goodall AD, Yiannakou G, Chechik L, Mitchell RL, Jewell GW, Todd I. Geometrical control of eddy currents in additively manufactured Fe-Si. Materials & Design. 2023;230:112002. doi:10.1016/j.matdes.2023.112002

BibTeX
@article{Goodall2023,
  author = {Goodall, Alexander D. and Yiannakou, Georgios and Chechik, Lova and Mitchell, Ria L. and Jewell, Geraint W and Todd, Iain},
  title = {Geometrical control of eddy currents in additively manufactured Fe-Si},
  journal = {Materials & Design},
  year = {2023},
  volume = {230},
  pages = {112002},
  doi = {10.1016/j.matdes.2023.112002}
}
Kostenlos starten →