Source of lateralization in reverse total shoulder arthroplasty matters: a comparison of glenoid and humeral lateralization on rotator cuff biomechanics
Journal of Shoulder and Elbow Surgery · 2026
DOI: 10.1016/j.jse.2026.02.021 ↗Kurz gefasst
Vergleichsstudie in der Zeitschrift Journal of Shoulder and Elbow Surgery, 2026. Verfasst von Christopher M Brusalis und 8 weiteren Autor:innen. Beteiligte Einrichtung: Department of Sports Medicine and Shoulder Surgery, Hospital for Special Surgery, New York, NY, USA. Electronic address: brusalisc@hss.edu. Hauptthemen laut MEDLINE: Arthroplasty, Replacement, Shoulder, Rotator Cuff, Shoulder Joint, Shoulder Prosthesis. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 36 Literaturangaben. Gefördert von: Hospital for Special Surgery.
Abstract (Originalsprache)
BACKGROUND: Compared with the traditional Grammont design, modern reverse total shoulder arthroplasty (rTSA) implant designs often introduce lateralization of the glenoid and/or humeral components. This study aimed to evaluate the impact of different strategies for achieving lateralization (ie, humeral or glenoid lateralization) in rTSA implant design on rotator cuff biomechanics. METHODS: Computed tomography scans from 16 nonosteoarthritic subjects were used to build customized computational 3-dimensional shoulder models based on the Newcastle Shoulder Model. Four rTSA implant constructs were created: (1) medialized glenoid-medialized humerus (MG-MH); (2) medialized glenoid-lateralized humerus (MG-LH); (3) lateralized glenoid-medialized humerus (LG-MH); and (4) lateralized glenoid-lateralized humerus (LG-LH). All constructs used a humeral stem with 135° neck-shaft angle where the diameter of the glenosphere was 36mm. Simulated rTSA constructs included a subscapularis tendon repaired to its native attachment on the lesser tuberosity. For each design construct, moment arms for both the subscapularis and infraspinatus were calculated for 4 motions: humeral elevation in frontal and scapular plane, internal/external rotation at 20° and 90° of abduction. Moment arms for each construct were also compared to those in a native shoulder. RESULTS: All rTSA constructs influenced the moment arms of the rotator cuff muscles. During humeral elevation, both the subscapularis and infraspinatus exhibited increased adductive moment arms compared to the native shoulder, particularly at lower angles of elevation (0-80° in abduction and 0-50° in the scapular plane). Glenoid lateralization did not significantly affect these changes; however, humeral lateralization enhanced the adductive moment arms of both muscles. Additionally, all rTSA constructs altered the internal and external rotation moment arms of the RC muscles relative to the native shoulder. The subscapularis showed increased internal rotation moment arms that got larger than the native shoulder only after 40° of internal rotation, while the infraspinatus demonstrated increased external rotation moment arms during all external rotation range of motion. Again, glenoid lateralization did not significantly impact these rotational moment arms, whereas humeral lateralization led to an increase in both internal (subscapularis) and external (infraspinatus) rotation moment arms. CONCLUSIONS: While glenoid lateralization of an rTSA implant construct does not substantially alter rotator cuff moment arms, humeral lateralization may have a dual effect: potentially introducing an antagonistic adductive moment relative to the deltoid during early abduction, while also augmenting beneficial rotational moment arms-namely, increased internal rotation from the subscapularis and increased external rotation from the infraspinatus.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Sports Medicine and Shoulder Surgery, Hospital for Special Surgery, New York, NY, USA. Electronic address: brusalisc@hss.edu.
- Leon Root Motion Analysis Laboratory, Rehabilitation Department, Hospital for Special Surgery, New York, NY, USA.
- Department of Sports Medicine and Shoulder Surgery, Hospital for Special Surgery, New York, NY, USA.
Förderung
- Hospital for Special Surgery
Zitieren
APA
Brusalis, C. M., Glenday, J., Fu, M. C., Dines, J. S., Blaine, T. A., Dines, D. M., Gulotta, L. V., Taylor, S. A., & Kontaxis, A. (2026). Source of lateralization in reverse total shoulder arthroplasty matters: a comparison of glenoid and humeral lateralization on rotator cuff biomechanics. Journal of Shoulder and Elbow Surgery. https://doi.org/10.1016/j.jse.2026.02.021
Vancouver
Brusalis CM, Glenday J, Fu MC, Dines JS, Blaine TA, Dines DM, et al. Source of lateralization in reverse total shoulder arthroplasty matters: a comparison of glenoid and humeral lateralization on rotator cuff biomechanics. Journal of Shoulder and Elbow Surgery. 2026. doi:10.1016/j.jse.2026.02.021
BibTeX
@article{Brusalis2026,
author = {Brusalis, Christopher M and Glenday, Jonathan and Fu, Michael C and Dines, Joshua S and Blaine, Theodore A and Dines, David M and Gulotta, Lawrence V and Taylor, Samuel A and Kontaxis, Andreas},
title = {Source of lateralization in reverse total shoulder arthroplasty matters: a comparison of glenoid and humeral lateralization on rotator cuff biomechanics},
journal = {Journal of Shoulder and Elbow Surgery},
year = {2026},
doi = {10.1016/j.jse.2026.02.021}
}
EUVIMED