EUVIMEDEUVIMED entdecken
Open Access

Review of materials for engineering and design of 3D-printed electrochemical sensors

Teflah Alshammari, Alexander G Zestos

Electrochimica Acta · 2026-10 · 573 · 149224

DOI: 10.1016/j.electacta.2026.149224 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electrochimica Acta, 2026-10. Verfasst von Teflah Alshammari und 1 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemistry, American University, Washington, D.C., USA. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 83 Literaturangaben. Der Volltext ist frei in PubMed Central verfügbar. Gefördert von: NIMH NIH HHS, NINDS NIH HHS, Research Corporation for Science Advancement.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Three-dimensional (3D) printing is increasingly used to build electrochemical sensing platforms because it allows researchers to create complex geometries, combine multiple functional components in a single device, and adjust sensor designs to suit specific analytical applications. In this context, fused filament fabrication (FFF) has gained increasing attention for its ability to use conductive thermoplastic filaments and its suitability for rapid design iterations. This review summarizes recent research on electrochemical sensors produced by FFF printing, emphasizing how factors such as printing parameters, filament composition, post-printing processes, and device design affect electrochemical performance. The discussion also addresses ongoing issues with reproducibility, surface accessibility, and inconsistencies in reported performance. In addition, the review considers a range of routinely employed approaches to enhance electrode performance, including mechanical, chemical, and electrochemical activation, and stresses the importance of achieving an appropriate trade-off between sensitivity, stability, and other practical constraints.

Schlagwörter

Stichwörter der Autor:innen

3D printedadditive manufacturingbiosensorelectrochemical sensorelectrode

Autor:innen und Institutionen

  • Department of Chemistry, American University, Washington, D.C., USA.
  • Department of Physics, Catholic University of America, Washington, D.C., USA.
  • Department of Physics, University of Hafar Al Batin, Hafar Al Batin, Saudi Arabia.

Förderung

  • NIMH NIH HHS
  • NINDS NIH HHS
  • Research Corporation for Science Advancement
  • National Institute of Mental Health
  • ACS Petroleum Research Fund
  • District of Columbia Developmental Center for AIDS Research
  • National Institutes of Health
  • National Science Foundation

Zitieren

APA

Alshammari, T., & Zestos, A. G. (2026). Review of materials for engineering and design of 3D-printed electrochemical sensors. Electrochimica Acta, 573, 149224. https://doi.org/10.1016/j.electacta.2026.149224

Vancouver

Alshammari T, Zestos AG. Review of materials for engineering and design of 3D-printed electrochemical sensors. Electrochimica Acta. 2026;573:149224. doi:10.1016/j.electacta.2026.149224

BibTeX
@article{Alshammari2026,
  author = {Alshammari, Teflah and Zestos, Alexander G},
  title = {Review of materials for engineering and design of 3D-printed electrochemical sensors},
  journal = {Electrochimica Acta},
  year = {2026},
  volume = {573},
  pages = {149224},
  doi = {10.1016/j.electacta.2026.149224}
}
Kostenlos starten →