Tribological mechanisms of slurry abrasive wear
Friction · 2023-06 · 11 (6) · 1079-1093
DOI: 10.1007/s40544-022-0654-1 ↗Kurz gefasst
Fachartikel in der Zeitschrift Friction, online erschienen am 28.07.2022. Verfasst von Yulong Li und 3 weiteren Autor:innen. Die Arbeit wurde bisher 49-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Abrasive wear mechanisms—including two-body and three-body abrasion—dominate the performance and lifespan of tribological systems in many engineering fields, even of those operating in lubricated conditions. Bearing steel (100Cr6) pins and discs in a flat-on-flat contact were utilized in experiments together with 5 and 13 µm Al 2 O 3 -based slurries as interfacial media to shed light on the acting mechanisms. The results indicate that a speed-induced hydrodynamic effect occurred and significantly altered the systems’ frictional behavior in tests that were performed using the 5 µm slurry. Further experiments revealed that a speed-dependent hydrodynamic effect can lead to a 14% increase in film thickness and a decrease in friction of around 2/3, accompanied by a transition from two-body abrasion to three-body abrasion and a change in wear mechanism from microcutting and microploughing to fatigue wear. Surprisingly, no correlation could be found between the total amount of wear and the operating state of the system during the experiment; however, the wear distribution over pin and disc was observed to change significantly. This paper studies the influence of the hydrodynamic effect on the tribological mechanism of lubricated abrasive wear and also highlights the importance to not only consider a tribological systems’ global amount of wear.
Zitieren
APA
Li, Y., Schreiber, P., Schneider, J., & Greiner, C. (2023). Tribological mechanisms of slurry abrasive wear. Friction, 11(6), 1079-1093. https://doi.org/10.1007/s40544-022-0654-1
Vancouver
Li Y, Schreiber P, Schneider J, Greiner C. Tribological mechanisms of slurry abrasive wear. Friction. 2023;11(6):1079-1093. doi:10.1007/s40544-022-0654-1
BibTeX
@article{Li2023,
author = {Li, Yulong and Schreiber, Paul and Schneider, Johannes and Greiner, Christian},
title = {Tribological mechanisms of slurry abrasive wear},
journal = {Friction},
year = {2023},
volume = {11},
number = {6},
pages = {1079--1093},
doi = {10.1007/s40544-022-0654-1}
}
EUVIMED