EUVIMEDEUVIMED entdecken
Crossref

Development of a voltage-divider-based probe method for sheet resistance measurement of copper foils and thin films

Mehrangiz Kazemi, Hossein Miar-Naimi, Majid Abbasi, Marzieh Abbasi-Firouzjah

Journal of Materials Science: Materials in Electronics · 2026-11 · 37 (32)

DOI: 10.1007/s10854-026-18802-8 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Materials Science: Materials in Electronics, online erschienen am 03.11.2026. Verfasst von Mehrangiz Kazemi und 3 weiteren Autor:innen. Die Arbeit nennt 31 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Accurate measurement of sheet resistance is essential for the electrical characterization of thin metallic films and foils, particularly when sample dimensions and thickness approach the limits of conventional probe-based techniques. A voltage-divider-based probe method was developed for measuring the sheet resistance of copper samples over micrometer- and nanometer-scale thicknesses. The proposed system combines a controlled electrical measurement circuit with a digital data-acquisition unit and was designed to reduce the sensitivity of the measurement to probe spacing and sample geometry under defined dimensional conditions. Copper foils with thicknesses from 20 to 100 μm and thermally evaporated copper films with thicknesses of approximately 32–529 nm were investigated. The sheet resistance and electrical resistivity obtained using the proposed method were compared with measurements performed using a conventional four-point probe. For micrometer-thick copper foils, the two methods produced closely comparable resistivity values, indicating good agreement between the proposed method and the four-point probe measurements under the experimental conditions used. At the nanometer scale, the proposed method remained capable of measuring samples thinner than 100 nm, for which the four-point-probe measurements were not obtained under the experimental conditions used in this study. The measured resistivity increased with decreasing film thickness, consistent with enhanced electron scattering associated with size-dependent transport. The results demonstrate that the proposed voltage-divider-based method can provide a simple and reproducible approach for sheet resistance characterization of small copper foils and thin films, while its applicability to ultrathin and nonuniform samples should be considered within the assumptions of the measurement model.

Zitieren

APA

Kazemi, M., Miar-Naimi, H., Abbasi, M., & Abbasi-Firouzjah, M. (2026). Development of a voltage-divider-based probe method for sheet resistance measurement of copper foils and thin films. Journal of Materials Science: Materials in Electronics, 37(32). https://doi.org/10.1007/s10854-026-18802-8

Vancouver

Kazemi M, Miar-Naimi H, Abbasi M, Abbasi-Firouzjah M. Development of a voltage-divider-based probe method for sheet resistance measurement of copper foils and thin films. Journal of Materials Science: Materials in Electronics. 2026;37(32). doi:10.1007/s10854-026-18802-8

BibTeX
@article{Kazemi2026,
  author = {Kazemi, Mehrangiz and Miar-Naimi, Hossein and Abbasi, Majid and Abbasi-Firouzjah, Marzieh},
  title = {Development of a voltage-divider-based probe method for sheet resistance measurement of copper foils and thin films},
  journal = {Journal of Materials Science: Materials in Electronics},
  year = {2026},
  volume = {37},
  number = {32},
  doi = {10.1007/s10854-026-18802-8}
}
Kostenlos starten →