EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Muscle and joint mechanics during maximum force biting following total temporomandibular joint replacement surgery

Sarah C Woodford, Dale L Robinson, Jaafar Abduo, Peter V S Lee, David C Ackland

Biomechanics and Modeling in Mechanobiology · 2024-06 · 23 (3) · 809-823

DOI: 10.1007/s10237-023-01807-1 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Biomechanics and Modeling in Mechanobiology, online erschienen am 19.03.2024. Verfasst von Sarah C Woodford und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Biomedical Engineering, University of Melbourne, Parkville, VIC, 3010, Australia. s.woodford@unimelb.edu.au. Hauptthemen laut MEDLINE: Bite Force, Temporomandibular Joint, Finite Element Analysis. Die Arbeit wurde bisher 17-mal zitiert (Crossref) und nennt 58 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Australian Research Council, University of Melbourne.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Total temporomandibular joint replacement (TMJR) surgery is the established treatment for severe temporomandibular joint disorders. While TMJR surgery is known to increase mouth-opening capacity, reduce pain and improve quality of life, little is known about post-surgical jaw function during activities of daily living such as biting and chewing. The aim of this study was to use subject-specific 3D bite force measurements to evaluate the magnitude and direction of joint loading in unilateral total TMJR patients and compare these data to those in healthy control subjects. An optoelectronic tracking system was used to measure jaw kinematics while biting a rubber sample for 5 unilateral total TMJR patients and 8 controls. Finite element simulations driven by the measured kinematics were employed to calculate the resultant bite force generated when compressing the rubber between teeth during biting tasks. Subject-specific musculoskeletal models were subsequently used to calculate muscle and TMJ loading. Unilateral total TMJR patients generated a bite force of 249.6 ± 24.4 N and 164.2 ± 62.3 N when biting on the contralateral and ipsilateral molars, respectively. In contrast, controls generated a bite force of 317.1 ± 206.6 N. Unilateral total TMJR patients biting on the contralateral molars had a significantly higher lateral TMJ force direction (median difference: 63.6°, p = 0.028) and a significantly lower ratio of working TMJ force to bite force (median difference: 0.17, p = 0.049) than controls. Results of this study may guide TMJ prosthesis design and evaluation of dental implants.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Bite ForceTemporomandibular JointFinite Element AnalysisHumansBiomechanical PhenomenaFemaleMaleMiddle AgedAdultArthroplasty, ReplacementMasticationCase-Control StudiesMusclesTemporomandibular Joint Disorders

Stichwörter der Autor:innen

Biomechanical modelChewingFinite element analysisMotion analysisMusculoskeletal modelTemporomandibular joint

Autor:innen und Institutionen

  • Department of Biomedical Engineering, University of Melbourne, Parkville, VIC, 3010, Australia. s.woodford@unimelb.edu.au.
  • Department of Biomedical Engineering, University of Melbourne, Parkville, VIC, 3010, Australia.
  • Melbourne Dental School, University of Melbourne, Parkville, VIC, 3010, Australia.

Förderung

  • Australian Research Council
  • University of Melbourne

Zitieren

APA

Woodford, S. C., Robinson, D. L., Abduo, J., Lee, P. V. S., & Ackland, D. C. (2024). Muscle and joint mechanics during maximum force biting following total temporomandibular joint replacement surgery. Biomechanics and Modeling in Mechanobiology, 23(3), 809-823. https://doi.org/10.1007/s10237-023-01807-1

Vancouver

Woodford SC, Robinson DL, Abduo J, Lee PVS, Ackland DC. Muscle and joint mechanics during maximum force biting following total temporomandibular joint replacement surgery. Biomechanics and Modeling in Mechanobiology. 2024;23(3):809-823. doi:10.1007/s10237-023-01807-1

BibTeX
@article{Woodford2024,
  author = {Woodford, Sarah C and Robinson, Dale L and Abduo, Jaafar and Lee, Peter V S and Ackland, David C},
  title = {Muscle and joint mechanics during maximum force biting following total temporomandibular joint replacement surgery},
  journal = {Biomechanics and Modeling in Mechanobiology},
  year = {2024},
  volume = {23},
  number = {3},
  pages = {809--823},
  doi = {10.1007/s10237-023-01807-1}
}
Kostenlos starten →