EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Calibration of rotary axis angular positioning deviations in a six-axis robotic manipulator by using the R-Test

Tianhao Cui, Soichi Ibaraki

The International Journal of Advanced Manufacturing Technology · 07.09.2024

DOI: 10.1007/s00170-024-14260-w ↗

Kurz gefasst

Fachartikel in der Zeitschrift The International Journal of Advanced Manufacturing Technology, online erschienen am 07.09.2024. Verfasst von Tianhao Cui und 1 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: JSPS KAKENHI, Hiroshima University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Prediction accuracy of the kinematic model plays a pivotal role in offline numerical compensation for three-dimensional (3D) positioning error of a six-axis robotic manipulator. In addition to the Denavit-Hartenberg (D-H) error that was typically discussed in the analogous research, this paper proposes a novel scheme to identify the bidirectional angular positioning deviations of all the rotary axes without using the commercial laser tracker. This proposed scheme employs the R-Test, which is significantly more cost-efficient than a laser tracker employed in many past works. Compared to the conventional D-H model, significantly improved prediction performance of the proposed model was experimentally investigated on three rectangular paths covering the entire workspace. Experimental results indicate that the proposed scheme reduces the residual error from 505.2 to 215.2 mm, compared to 118.8 mm with a laser tracker, while maintaining a significantly lower cost that is 1/100 of a commercial laser tracker. Uncertainty analysis also clarify that when only the D-H error parameters are identified, as in many conventional works, the angular positioning deviations can be a major uncertainty contributor to the identification of the D-H errors. The proposed scheme does not require the R-Test locations to be calibrated, and its influence on the uncertainty in the identified errors is assessed.

Förderung

  • JSPS KAKENHI
  • Hiroshima University

Zitieren

APA

Cui, T., & Ibaraki, S. (2024). Calibration of rotary axis angular positioning deviations in a six-axis robotic manipulator by using the R-Test. The International Journal of Advanced Manufacturing Technology. https://doi.org/10.1007/s00170-024-14260-w

Vancouver

Cui T, Ibaraki S. Calibration of rotary axis angular positioning deviations in a six-axis robotic manipulator by using the R-Test. The International Journal of Advanced Manufacturing Technology. 2024. doi:10.1007/s00170-024-14260-w

BibTeX
@article{Cui2024,
  author = {Cui, Tianhao and Ibaraki, Soichi},
  title = {Calibration of rotary axis angular positioning deviations in a six-axis robotic manipulator by using the R-Test},
  journal = {The International Journal of Advanced Manufacturing Technology},
  year = {2024},
  doi = {10.1007/s00170-024-14260-w}
}
Kostenlos starten →