The modified tension chord model for reinforced concrete structures in service conditions: Accounting for the effects of internal cracks and concrete cover
Structural Concrete · 18.11.2026
DOI: 10.1002/suco.70880 ↗Kurz gefasst
Fachartikel in der Zeitschrift Structural Concrete, online erschienen am 18.11.2026. Verfasst von Maurizio Taliano und 1 weiteren Autor:innen. Die Arbeit nennt 42 Literaturangaben.
Abstract (Originalsprache)
Crack width control is a primary serviceability requirement in reinforced concrete design, yet current models— fib Model Code 2020 and Eurocode 2 included—rest on three simplifying assumptions that conflict with experimental and numerical evidence: the average bond stress depends only on concrete tensile strength; internal (Goto) cracks are neglected; and the tension‐stiffening reduction is constant regardless of the load level. These limitations become increasingly significant in the stabilized cracking stage, where iterative procedures are otherwise required. This paper proposes the Modified Tension Chord Model ( MTCM ), a closed‐form analytical model for reinforced concrete ties under monotonic short‐term loading, covering both the crack formation and the stabilized cracking stages. Building on a simplified model available in the literature based on linear distribution of the steel and concrete stresses or a refined model that considers the effect of internal cracks, but requires iterative procedures, MTCM assumes bi‐linear profiles of the bond stress over the transmission length and accounts for the effect of the internal cracks in the stabilized cracking stage through an appropriate reduction of the bond stress in the vicinity of a primary crack and applies the fib MC2020 bond law at the single section of maximum bond stress. This yields explicit formulae for the average bond stress, transmission length, and crack width—all free of iteration and dependent on the main factors governing the cracking behavior such as the concrete tensile strength, the bar diameter and the reinforcement ratio. The principal novelty is an ‐coefficient, dependent solely on the ratio of applied force to cracking force, which improves the formula of fib MC2020 and Eurocode 2 overcoming their load‐independent form of the tension‐stiffening effect. At the stabilized cracking stage, MTCM also delivers upper and lower bounds for crack width; an additive cover‐dependent term further extends the model to the class of combined approaches. Validation against six independent experimental campaigns (225 tests; –; –; –7.6%; –90 mm) confirms conservative upper‐bound predictions throughout, with a physically consistent representation of tension‐stiffening degradation.
Zitieren
APA
Taliano, M., & Marano, G. C. (2026). The modified tension chord model for reinforced concrete structures in service conditions: Accounting for the effects of internal cracks and concrete cover. Structural Concrete. https://doi.org/10.1002/suco.70880
Vancouver
Taliano M, Marano GC. The modified tension chord model for reinforced concrete structures in service conditions: Accounting for the effects of internal cracks and concrete cover. Structural Concrete. 2026. doi:10.1002/suco.70880
BibTeX
@article{Taliano2026,
author = {Taliano, Maurizio and Marano, Giuseppe Carlo},
title = {The modified tension chord model for reinforced concrete structures in service conditions: Accounting for the effects of internal cracks and concrete cover},
journal = {Structural Concrete},
year = {2026},
doi = {10.1002/suco.70880}
}
EUVIMED