EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The influence of secondary reinforcement on a strut‐and‐tie model for the design of reinforced concrete corbels

Rejane Martins Fernandes Canha, Kycianne Rose Alves de Góes Barros, Laynara Freitas Lima Vieira, Mounir Khalil El Debs

Structural Concrete · 02.06.2026

DOI: 10.1002/suco.70644 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Structural Concrete, online erschienen am 02.06.2026. Verfasst von Rejane Martins Fernandes Canha und 3 weiteren Autor:innen. Die Arbeit nennt 65 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Coordenação de Aperfeiçoamento de Pessoal de Nível Superior.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In precast concrete structures, optimizing the design of corbels by considering the contributions of secondary reinforcement elements can significantly improve construction economy, especially when corbels are repeated multiple times. This paper proposes a strut‐and‐tie model for reinforced concrete corbels subjected to vertical and/or horizontal loads, focusing on the effective utilization of secondary reinforcement, which is often neglected in conventional load capacity calculations. The proposed model was validated using experimental data from 397 corbels reported in the technical literature. Additionally, a comparative analysis was performed with three reference models to evaluate its performance. Key parameters, such as the horizontal‐to‐vertical load ratio and corbel aspect ratio, were analyzed for their influence on corbel strength. The results demonstrated that the proposed model provides a broader and safer application range compared to the reference models, with approximately 99% of the tested corbels aligning with its predictions. Furthermore, incorporating secondary reinforcement in the proposed model enhanced structural efficiency, yielding a mean strength improvement of approximately 22% based on the tie‐yielding failure criterion. These results highlight the model's potential to achieve both safety and economic viability in the design of precast concrete corbels.

Förderung

  • Coordenação de Aperfeiçoamento de Pessoal de Nível Superior

Zitieren

APA

Canha, R. M. F., Barros, K. R. A. D. G., Vieira, L. F. L., & Debs, M. K. E. (2026). The influence of secondary reinforcement on a strut‐and‐tie model for the design of reinforced concrete corbels. Structural Concrete. https://doi.org/10.1002/suco.70644

Vancouver

Canha RMF, Barros KRADG, Vieira LFL, Debs MKE. The influence of secondary reinforcement on a strut‐and‐tie model for the design of reinforced concrete corbels. Structural Concrete. 2026. doi:10.1002/suco.70644

BibTeX
@article{Canha2026,
  author = {Canha, Rejane Martins Fernandes and Barros, Kycianne Rose Alves de Góes and Vieira, Laynara Freitas Lima and Debs, Mounir Khalil El},
  title = {The influence of secondary reinforcement on a strut‐and‐tie model for the design of reinforced concrete corbels},
  journal = {Structural Concrete},
  year = {2026},
  doi = {10.1002/suco.70644}
}
Kostenlos starten →