EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Sodium Incorporation for Performance Improvement of Solution‐Processed Submicron CuIn(S,Se) 2 Thin Film Solar Cells

Yao Gao iD, Guanchao Yin, Martina Schmid iD

Small · 2023-10 · 19 (42)

DOI: 10.1002/smll.202302581 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Small, online erschienen am 16.06.2023. Verfasst von Yao Gao und 2 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Physics and Center for Nanointegration Duisburg-Essen (CENIDE), University of Duisburg-Essen, Forsthausweg 2, 47057, Duisburg, Germany. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 50 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Deutsche Forschungsgemeinschaft, National Natural Science Foundation of China, Fundamental Research Funds for the Central Universities.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Low‐cost solution‐processed CuIn(S,Se) 2 (CISSe) has great potential for large‐scale production of photovoltaics (PV). However, low power conversion efficiency caused by poor crystallinity is one of the main drawbacks compared to vacuum‐processed CISSe solar cells. In this work, three strategies for sodium (Na) incorporation into solution‐processed CISSe by soaking in sodium chloride (NaCl) aqueous‐ethanol solution [1 molarity (M) for 10 minutes (min)], either prior to absorber deposition (pre‐deposition treatment, Pre‐DT), before selenization (pre‐selenization treatment, Pre‐ST), or after selenization (post‐selenization treatment, PST) are researched. The Pre‐ST CISSe solar cells achieve a better PV performance than those from the other two strategies of Na incorporation. For optimization, soaking times (5, 10, and 15 min) and NaCl concentrations (from 0.2 to 1.2 m ) of the Pre‐ST are researched. The highest efficiency achieved is 9.6% with an open‐circuit voltage ( V oc ) of 464.5 mV, a short‐circuit current density ( j sc ) of 33.4 mA cm −2 , and a fill factor ( FF ) of 62.0%. Compared to the reference CISSe solar cell, V oc , j sc , FF , and efficiency of the champion Pre‐ST CISSe device are improved absolutely by 61.0 mV, 6.5 mA cm −2 , 9%, and 3.8%, respectively. Simultaneously, the open‐circuit voltage deficit, the back contact barrier, and the bulk recombination are found to be reduced for Pre‐ST CISSe.

Schlagwörter

Stichwörter der Autor:innen

CISSeNa incorporationNaCl aqueous-ethanol solutionpre-selenization treatmentsolution process

Autor:innen und Institutionen

  • Faculty of Physics and Center for Nanointegration Duisburg-Essen (CENIDE), University of Duisburg-Essen, Forsthausweg 2, 47057, Duisburg, Germany.
  • School of Materials Science and Engineering, Wuhan University of Technology, Luoshi Road 122, Wuhan, 430070, China.

ORCID-Profile: Yao Gao, Martina Schmid

Förderung

  • Deutsche Forschungsgemeinschaft
  • National Natural Science Foundation of China
  • Fundamental Research Funds for the Central Universities

Zitieren

APA

Gao, Y., Yin, G., & Schmid, M. (2023). Sodium Incorporation for Performance Improvement of Solution‐Processed Submicron CuIn(S,Se) 2 Thin Film Solar Cells. Small, 19(42). https://doi.org/10.1002/smll.202302581

Vancouver

Gao Y, Yin G, Schmid M. Sodium Incorporation for Performance Improvement of Solution‐Processed Submicron CuIn(S,Se) 2 Thin Film Solar Cells. Small. 2023;19(42). doi:10.1002/smll.202302581

BibTeX
@article{Gao2023,
  author = {Gao, Yao and Yin, Guanchao and Schmid, Martina},
  title = {Sodium Incorporation for Performance Improvement of Solution‐Processed Submicron CuIn(S,Se) 2 Thin Film Solar Cells},
  journal = {Small},
  year = {2023},
  volume = {19},
  number = {42},
  doi = {10.1002/smll.202302581}
}
Kostenlos starten →