Droplet size spectrum, velocity, angle and flow rate of pulse‐width‐modulated spray nozzles with adjuvants
Pest Management Science · 2026-09 · 82 (9) · 8831-8843
DOI: 10.1002/ps.70932 ↗At a glance
Journal article in Pest Management Science, published online on 2026-05-15. Written by João Paulo Arantes Rodrigues da Cunha and 3 co-authors. Institution: Institute of Agrarian Sciences, Federal University of Uberlândia, Uberlândia, Brazil. Major MEDLINE topics: Pesticides, Aerosolized Particles and Droplets. Cited 1 times so far (Crossref); 41 references. The full text is freely available (open access, CC BY 4.0). Funded by: Conselho Nacional de Desenvolvimento Científico e Tecnológico.
Abstract (original language)
BACKGROUND Droplet size distribution, droplet velocity, spray angle and flow rate are key factors influencing pesticide efficacy and environmental impact. However, it remains poorly understood how these parameters are affected by the interaction among pulse‐width modulation (PWM), nozzle types and, in particular, spray adjuvants. This study investigated these factors using four flat‐fan nozzle types (standard with 80° and 110° spray angles, pre‐orifice and air‐induction). Water and two commercial adjuvant formulations [a nonionic surfactant (NIS), and a drift control agent (DCA)] were used across five PWM duty cycles (20%, 40%, 60%, 80% and 100%). RESULTS PWM duty cycle primarily governed flow rate, which was mostly unaffected by spray solution. By contrast, droplet size distribution was strongly affected by adjuvant type, duty cycle and nozzle type. Generally, droplet size increased as duty cycle decreased for all nozzle types, regardless of spray solution. Adjuvants further modified droplet size at each duty cycle: DCA markedly increased droplet size and reduced fine droplets, whereas NIS produced a moderate increase compared with water. Both adjuvants tended to produce more uniform droplet size spectra, mitigating the PWM tendency to increase the relative span index at lower duty cycles. Decreasing the duty cycle consistently narrowed the spray angle, with the air‐induction nozzle showing the greatest sensitivity owing to incomplete sheet development under short valve‐open times. CONCLUSION These findings demonstrate that optimizing PWM‐controlled spray performance requires not only appropriate duty cycle selection, but also the use of adjuvant formulations tailored to each nozzle type. © 2026 The Author(s). Pest Management Science published by John Wiley & Sons Ltd on behalf of Society of Chemical Industry.
Subjects
MeSH terms (MEDLINE)
Author keywords
Substances
Authors and institutions
- Institute of Agrarian Sciences, Federal University of Uberlândia, Uberlândia, Brazil.
- Department of Food, Agricultural and Biological Engineering, The Ohio State University, Columbus, OH, USA.
- Application Technology Research Unit, United States Department of Agriculture, Wooster, OH, USA.
ORCID profiles: João Paulo Arantes Rodrigues da Cunha
Funding
- Conselho Nacional de Desenvolvimento Científico e Tecnológico
Cite
APA
da Cunha, J. P. A. R., Ozkan, E., Jeon, H., & Zhu, H. (2026). Droplet size spectrum, velocity, angle and flow rate of pulse‐width‐modulated spray nozzles with adjuvants. Pest Management Science, 82(9), 8831-8843. https://doi.org/10.1002/ps.70932
Vancouver
da Cunha JPAR, Ozkan E, Jeon H, Zhu H. Droplet size spectrum, velocity, angle and flow rate of pulse‐width‐modulated spray nozzles with adjuvants. Pest Management Science. 2026;82(9):8831-8843. doi:10.1002/ps.70932
BibTeX
@article{daCunha2026,
author = {da Cunha, João Paulo Arantes Rodrigues and Ozkan, Erdal and Jeon, Hongyoung and Zhu, Heping},
title = {Droplet size spectrum, velocity, angle and flow rate of pulse‐width‐modulated spray nozzles with adjuvants},
journal = {Pest Management Science},
year = {2026},
volume = {82},
number = {9},
pages = {8831--8843},
doi = {10.1002/ps.70932}
}
EUVIMED