Application of artificial neural network to evaluation of dimensional accuracy of 3D‐printed polylactic acid parts
Journal of Polymer Science · 2024-05 · 62 (9) · 1864-1889
DOI: 10.1002/pol.20230876 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Polymer Science, online erschienen am 23.01.2024. Verfasst von Seyhmus Gunes und 2 weiteren Autor:innen. Die Arbeit wurde bisher 30-mal zitiert (Crossref) und nennt 62 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Additive manufacturing (AM) has begun to replace traditional fabrication because of its advantages, such as easy manufacturing of parts with complex geometry, and mass production. The most important limitation of AM is that dimensional accuracy cannot be achieved in all parts. Dimensional accuracy is essential for high reliability, high performance, and useful final products. This study investigates the impact of printing parameters on the dimensional accuracy of samples fabricated through fused deposition modeling (FDM), an additive manufacturing (AM) method utilizing polylactic acid (PLA) material. The experimental design process was performed using Taguchi methodology. ANOVA was used to determine the most important parameter affecting accuracy. Based on experimental studies, the optimal printing parameters for parts are determined as follows: concentric infill pattern, 3 mm wall thickness, 70% infill density, and a layer thickness of 200 μm. Artificial neural network (ANN) was used in the evaluation and prediction of the results. The R ‐square ( R 2 ) performance evaluation criterion was above 95% from the ANN results. This value shows that the results are significant. The data acquired from this study may assist in identifying optimal parameters that contribute to the fabrication of samples with high dimensional accuracy using the FDM method.
Zitieren
APA
Gunes, S., Ulkir, O., & Kuncan, M. (2024). Application of artificial neural network to evaluation of dimensional accuracy of 3D‐printed polylactic acid parts. Journal of Polymer Science, 62(9), 1864-1889. https://doi.org/10.1002/pol.20230876
Vancouver
Gunes S, Ulkir O, Kuncan M. Application of artificial neural network to evaluation of dimensional accuracy of 3D‐printed polylactic acid parts. Journal of Polymer Science. 2024;62(9):1864-1889. doi:10.1002/pol.20230876
BibTeX
@article{Gunes2024,
author = {Gunes, Seyhmus and Ulkir, Osman and Kuncan, Melih},
title = {Application of artificial neural network to evaluation of dimensional accuracy of 3D‐printed polylactic acid parts},
journal = {Journal of Polymer Science},
year = {2024},
volume = {62},
number = {9},
pages = {1864--1889},
doi = {10.1002/pol.20230876}
}
EUVIMED