EUVIMEDEUVIMED entdecken
Crossref

Improvement of catheter tip morphology by mold material used for tip‐forming process

Gye Jun Lee, Wonjin Jun, Han Chang Lee, Seong Wook Choi, Gyu Man Kim, Woojin Kim

Polymer Engineering & Science · 2023-08 · 63 (8) · 2511-2521

DOI: 10.1002/pen.26392 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymer Engineering & Science, online erschienen am 21.06.2023. Verfasst von Gye Jun Lee und 5 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 24 Literaturangaben. Gefördert von: Ministry of Trade, Industry and Energy.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

As interventional procedures using catheters have rapidly developed, accordingly, the incidence of polymeric embolization is also increasing, with the main cause being the flash generated during tip forming of the catheter. This study has performed to change the material of the mold used to form catheter tips to prevent flash, which is a cause of polymeric embolism. The tip‐forming performance and the flash generation according to the main parameters of the tip‐forming process were analyzed: power, heating, cooling time, and insertion pressure. In addition, we observed the effect of flash suppression according to temperature sensitivity by changing the mold material considering thermal conductivity and electrical resistivity. In particular, considering the glass transition temperature of HDPE (high‐density polyethylene), which is applied to sheath and dilator catheters, the most stable tip forming proceeds when the temperature near the tip inside the mold was about 130°C. We verified experimentally and numerically that the temperature of the pins comprising the mold plays an important role in flash generation and confirmed that the viscosity of the polymer melts is lower at 120°C than at 90°C of the pin, and flash is minimized because of the shear‐thinning behavior of the polymer melts.

Förderung

  • Ministry of Trade, Industry and Energy

Zitieren

APA

Lee, G. J., Jun, W., Lee, H. C., Choi, S. W., Kim, G. M., & Kim, W. (2023). Improvement of catheter tip morphology by mold material used for tip‐forming process. Polymer Engineering & Science, 63(8), 2511-2521. https://doi.org/10.1002/pen.26392

Vancouver

Lee GJ, Jun W, Lee HC, Choi SW, Kim GM, Kim W. Improvement of catheter tip morphology by mold material used for tip‐forming process. Polymer Engineering & Science. 2023;63(8):2511-2521. doi:10.1002/pen.26392

BibTeX
@article{Lee2023,
  author = {Lee, Gye Jun and Jun, Wonjin and Lee, Han Chang and Choi, Seong Wook and Kim, Gyu Man and Kim, Woojin},
  title = {Improvement of catheter tip morphology by mold material used for tip‐forming process},
  journal = {Polymer Engineering & Science},
  year = {2023},
  volume = {63},
  number = {8},
  pages = {2511--2521},
  doi = {10.1002/pen.26392}
}
Kostenlos starten →