EUVIMEDEUVIMED entdecken
Crossref

Improved Shear Behavior of Co‐Bonded and Secondary Bonded CFRP /Aluminum Dissimilar Joints Through Organo‐Modified Montmorillonite ( OMMT ) Infused Adhesive

Devarasu Anbuselvan, Jesuarockiam Naveen

Polymer Composites · 17.11.2026

DOI: 10.1002/pc.71857 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymer Composites, online erschienen am 17.11.2026. Verfasst von Devarasu Anbuselvan und 1 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Gefördert von: Vellore Institute of Technology, Chennai.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the shear performance of dissimilar single‐lap joints between CFRP and Al 6061, made by co‐bonding (CB) and secondary bonding (SB) techniques, with OMMT nanoclay reinforced epoxy matrix. OMMT was added in different weight fractions (0, 0.25, 0.5, 0.75, 1.00, and 1.25 wt%) to evaluate its impact on load transmission and strength of a joint. The experimental results indicated that the higher shear strength of 6 MPa was achieved for the SB joint with 1.0 wt% OMMT, representing an increase from 2.75 MPa for neat SB joint (125% improvement) and from 2.32 MPa for neat CB joint (178% improvement). At same OMMT concentration, the SB joint exhibited 96% higher shear strength than the CB. Nanoparticle reinforcement significantly improved the shear strength, shear modulus, and toughness of the adhesive joints. However, at higher OMMT concentrations, the mechanical performance decreased, which may be due to possible OMMT agglomeration. Among the two techniques, SB consistently delivered superior shear strength, modulus, and toughness because of improved adhesive wetting, as confirmed by contact angle measurements, and improved interfacial contact between adherend and adhesive surface. Furthermore, different ANN models based on Levenberg–Marquardt algorithm were developed for the prediction of maximum mechanical properties of CB and SB joints. The models showed good agreement with the experimental results with coefficient correlation from 0.9388 to 0.9677 and 0.9337 to 0.9823 for the CB and SB joints, respectively.

Förderung

  • Vellore Institute of Technology, Chennai

Zitieren

APA

Anbuselvan, D., & Naveen, J. (2026). Improved Shear Behavior of Co‐Bonded and Secondary Bonded CFRP /Aluminum Dissimilar Joints Through Organo‐Modified Montmorillonite ( OMMT ) Infused Adhesive. Polymer Composites. https://doi.org/10.1002/pc.71857

Vancouver

Anbuselvan D, Naveen J. Improved Shear Behavior of Co‐Bonded and Secondary Bonded CFRP /Aluminum Dissimilar Joints Through Organo‐Modified Montmorillonite ( OMMT ) Infused Adhesive. Polymer Composites. 2026. doi:10.1002/pc.71857

BibTeX
@article{Anbuselvan2026,
  author = {Anbuselvan, Devarasu and Naveen, Jesuarockiam},
  title = {Improved Shear Behavior of Co‐Bonded and Secondary Bonded CFRP /Aluminum Dissimilar Joints Through Organo‐Modified Montmorillonite ( OMMT ) Infused Adhesive},
  journal = {Polymer Composites},
  year = {2026},
  doi = {10.1002/pc.71857}
}
Kostenlos starten →