EUVIMEDAvasta EUVIMED
Crossref

Tribological Properties of Silicon Carbide‐Reinforced Polytetrafluoroethylene/Epoxy Resin Composite Coatings: Molecular Dynamics Simulation and Experimental Validation

Liuchao Wang, Xinfu Xie, Songyan Shi, Li Liu, Jiawei Xiang, Jun Cao

Polymer Composites · 2026-11-10 · 47 (21) · 19108-19122

DOI: 10.1002/pc.71532 ↗

At a glance

Journal article in Polymer Composites, published online on 2026-08-14. Written by Liuchao Wang and 5 co-authors. 53 references. Funded by: National Natural Science Foundation of China, Key Research and Development Program of Zhejiang Province.

AbstraktBibliograafilised andmedCiteRelated studies

Abstract (original language)

Wear‐induced failure of railway switch slide chairs remains a critical challenge, and conventional coating optimization still relies heavily on time‐consuming trial‐and‐error experiments. Therefore, molecular dynamics (MD) simulations combined with experimental investigations were employed to systematically investigate the effects of silicon carbide (SiC) content (0, 1, 3, 5, and 7 wt%) on the tribological properties of polytetrafluoroethylene/epoxy resin (PTFE/EP) composite coatings. Molecular models were constructed using Materials Studio, and friction behavior under room‐temperature dry sliding was simulated via shear displacement to obtain the coefficient of friction and wear rate, which were validated experimentally. Results show that increasing SiC content leads to a gradual increase in the coefficient of friction, while the wear rate exhibits a non‐monotonic trend, decreasing first and then increasing, with the optimum performance achieved at 5 wt% SiC (T5). The simulation and experimental results are in good agreement. Both indicate that T5 exhibits the lowest wear rate, corresponding to an MD‐derived wear parameter of 15.5% and an experimental wear rate of 0.21 × 10 −4 mm 3 N −1 m −1 . Wear morphology analysis reveals a transition from adhesive wear in the neat PTFE/EP coating to predominantly abrasive wear after SiC incorporation. These results confirm the reliability of the MD approach for designing PTFE/EP composite coatings.

Funding

  • National Natural Science Foundation of China
  • Key Research and Development Program of Zhejiang Province

Cite

APA

Wang, L., Xie, X., Shi, S., Liu, L., Xiang, J., & Cao, J. (2026). Tribological Properties of Silicon Carbide‐Reinforced Polytetrafluoroethylene/Epoxy Resin Composite Coatings: Molecular Dynamics Simulation and Experimental Validation. Polymer Composites, 47(21), 19108-19122. https://doi.org/10.1002/pc.71532

Vancouver

Wang L, Xie X, Shi S, Liu L, Xiang J, Cao J. Tribological Properties of Silicon Carbide‐Reinforced Polytetrafluoroethylene/Epoxy Resin Composite Coatings: Molecular Dynamics Simulation and Experimental Validation. Polymer Composites. 2026;47(21):19108-19122. doi:10.1002/pc.71532

BibTeX
@article{Wang2026,
  author = {Wang, Liuchao and Xie, Xinfu and Shi, Songyan and Liu, Li and Xiang, Jiawei and Cao, Jun},
  title = {Tribological Properties of Silicon Carbide‐Reinforced Polytetrafluoroethylene/Epoxy Resin Composite Coatings: Molecular Dynamics Simulation and Experimental Validation},
  journal = {Polymer Composites},
  year = {2026},
  volume = {47},
  number = {21},
  pages = {19108--19122},
  doi = {10.1002/pc.71532}
}
Start for free →