A Monolithic InGaP/GaAs HBT Front‐End Architecture for Continuous‐Wave Doppler Radar Sensors in Omnidirectional Moving Target Detection
Microwave and Optical Technology Letters · 2025-08 · 67 (8)
DOI: 10.1002/mop.70362 ↗At a glance
Journal article in Microwave and Optical Technology Letters, published online on 2025-08-17. Written by Kai Yi and 3 co-authors. Cited 1 times so far (Crossref); 27 references. Funded by: National Natural Science Foundation of China.
Abstract (original language)
This paper proposes a cost‐effective Doppler radar front‐end architecture based on InGaP/GaAs heterojunction bipolar transistor (HBT) technology for continuous‐wave (CW) omnidirectional moving target detection. The compact front‐end architecture integrates three core components—a mixer, a power divider, and an oscillator—on a monolithic microwave integrated circuit (MMIC). The power divider (PD) provides both the transmit signal and the local oscillator (LO) signal for the mixer. The oscillator employs a conventional cross‐coupled configuration, achieving a phase noise of −119.5 dBc/Hz at 1 MHz offset from the carrier frequency of 5.81 GHz. The compact transceiver achieves an area of 0.5 × 0.55 mm 2 while maintaining greater than 18 dB conversion gain over the entire 5.725–5.875 GHz ISM band. The total power consumption is less than 33 mW with a 3.3 V supply. Experimental measurements on two DRS testing systems demonstrated that the system's transmission power was approximately −2 dBm, and omnidirectional moving human presence detection tests indicated a horizontal detection distance greater than 4 meters when the radar system was mounted at a height of 3 meters.
Funding
- National Natural Science Foundation of China
Cite
APA
Yi, K., Lan, M., Liu, Y., & Liu, H. (2025). A Monolithic InGaP/GaAs HBT Front‐End Architecture for Continuous‐Wave Doppler Radar Sensors in Omnidirectional Moving Target Detection. Microwave and Optical Technology Letters, 67(8). https://doi.org/10.1002/mop.70362
Vancouver
Yi K, Lan M, Liu Y, Liu H. A Monolithic InGaP/GaAs HBT Front‐End Architecture for Continuous‐Wave Doppler Radar Sensors in Omnidirectional Moving Target Detection. Microwave and Optical Technology Letters. 2025;67(8). doi:10.1002/mop.70362
BibTeX
@article{Yi2025,
author = {Yi, Kai and Lan, Min and Liu, Yuwu and Liu, Huihua},
title = {A Monolithic InGaP/GaAs HBT Front‐End Architecture for Continuous‐Wave Doppler Radar Sensors in Omnidirectional Moving Target Detection},
journal = {Microwave and Optical Technology Letters},
year = {2025},
volume = {67},
number = {8},
doi = {10.1002/mop.70362}
}
EUVIMED