EUVIMEDEUVIMED entdecken
Crossref

Effects of Operating Mechanical Conditions and Polymer Networks of Nematic Elastomers on Photo‐Induced Mechanical Performances

Takuya Ohzono iD, Emiko Koyama iD

Macromolecular Rapid Communications · 2024

DOI: 10.1002/marc.202300709 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Macromolecular Rapid Communications, 2024. Verfasst von Takuya Ohzono und 1 weiteren Autor:innen. Beteiligte Einrichtung: Research Institute for Advanced Electronics and Photonics, National Institute of Advanced Industrial Science and Technology (AIST), 1-1-1 Higashi, Ts…. Hauptthemen laut MEDLINE: Elastomers, Liquid Crystals, Polymers. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 52 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Photoresponsive liquid‐crystalline elastomers (LCEs) are promising candidates for light‐controlled soft actuators. Photoinduced stress/strain originates from the changes in mechanical properties after light irradiation. However, the correlation between the photoinduced mechanical performance and in‐use conditions such as stress/strain states and polymer network properties (such as effective crosslink density and dangling chain density) remains unexplored for practical applications. Here, isometric photo‐induced stress or isotonic strain is investigated at different operating strains or stresses, respectively, on LCEs with polymer network variations, produced by different amounts of solvent during polymerization. As the solvent volume increases, the moduli and photoinduced stresses decrease. However, the photo‐induced strain, fracture strain, fracture stress, and viscosity increase. The optical response performance initially increases with the operating strain/stress, peaks at a higher actuation strain/stress, and then, decreases depending on the polymer network. The maximum work densities, which also depend on the operating stress, are in the range of ≈200–300 kJm −3 . These findings, highlighting the significant variations in the mechanical performance with the operating stress/strain ranges and amount of solvent used in the synthesis, are critical for designing LCE‐based mechanical devices.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

ElastomersLiquid CrystalsPolymersPhotochemical ProcessesLightPolymerizationViscosityStress, Mechanical

Stichwörter der Autor:innen

azobenzeneisometric photo‐stressisotonic photo‐strainliquid crystal elastomerphoto actuator

Substanzen

ElastomersPolymers

Autor:innen und Institutionen

  • Research Institute for Advanced Electronics and Photonics, National Institute of Advanced Industrial Science and Technology (AIST), 1-1-1 Higashi, Tsukuba, 305-8565, Japan.

ORCID-Profile: Takuya Ohzono, Emiko Koyama

Zitieren

APA

Ohzono, T., & Koyama, E. (2024). Effects of Operating Mechanical Conditions and Polymer Networks of Nematic Elastomers on Photo‐Induced Mechanical Performances. Macromolecular Rapid Communications. https://doi.org/10.1002/marc.202300709

Vancouver

Ohzono T, Koyama E. Effects of Operating Mechanical Conditions and Polymer Networks of Nematic Elastomers on Photo‐Induced Mechanical Performances. Macromolecular Rapid Communications. 2024. doi:10.1002/marc.202300709

BibTeX
@article{Ohzono2024,
  author = {Ohzono, Takuya and Koyama, Emiko},
  title = {Effects of Operating Mechanical Conditions and Polymer Networks of Nematic Elastomers on Photo‐Induced Mechanical Performances},
  journal = {Macromolecular Rapid Communications},
  year = {2024},
  doi = {10.1002/marc.202300709}
}
Kostenlos starten →