EUVIMEDScopri EUVIMED
VergleichsstudieOpen access · CC BY-NC-ND 4.0

Comparing Sensitivity of Different Bee Species to Pesticides: A TKTD modeling approach

Jan Baas, Benoit Goussen, Verena Taenzler, Vanessa Roeben, Mark Miles, Thomas G Preuss, Sanne van den Berg, Ivo Roessink

Environmental Toxicology and Chemistry · 2024-06-01 · 43 (6) · 1431-1441

DOI: 10.1002/etc.5871 ↗

At a glance

Vergleichsstudie in Environmental Toxicology and Chemistry, published online on 2024-06-01. Written by Jan Baas and 7 co-authors. Institution: Wageningen University and Research, Wageningen, The Netherlands. Major MEDLINE topics: Pesticides. Cited 11 times so far (Crossref); 34 references. The full text is freely available (open access, CC BY-NC-ND 4.0). Funded by: Bayer CropScience.

AbstractSubjectsDati bibliograficiCiteRelated studies

Abstract (original language)

Risk assessment for bees is mainly based on data for honey bees; however, risk assessment is intended to protect all bee species. This raises the question of whether data for honey bees are a good proxy for other bee species. This issue is not new and has resulted in several publications in which the sensitivity of bee species is compared based on the values of the 48-h median lethal dose (LD50) from acute test results. When this approach is used, observed differences in sensitivity may result both from differences in kinetics and from inherent differences in species sensitivity. In addition, the physiology of the bee, like its overall size, the size of the honey stomach (for acute oral tests), and the physical appearance (for acute contact tests) also influences the sensitivity of the bee. The recently introduced Toxicokinetic–Toxicodynamic (TKTD) model that was developed for the interpretation of honey bee tests (Bee General Uniform Threshold Model for Survival [BeeGUTS]) could integrate the results of acute oral tests, acute contact tests, and chronic tests within one consistent framework. We show that the BeeGUTS model can be calibrated and validated for other bee species and also that the honey bee is among the more sensitive bee species. In addition, we found that differences in sensitivity between species are smaller than previously published comparisons based on 48-h LD50 values. The time-dependency of the LD50 and the specifics of the bee physiology are the main causes of the wider variation found in the published literature. Environ Toxicol Chem 2024;43:1431–1441. © 2024 The Authors. Environmental Toxicology and Chemistry published by Wiley Periodicals LLC on behalf of SETAC.

Subjects

MeSH terms (MEDLINE)

PesticidesBeesAnimalsLethal Dose 50Models, BiologicalSpecies SpecificityRisk AssessmentToxicokinetics

Author keywords

Bee sensitivityGeneral Uniform Threshold Model for Survival (GUTS)ModelingPesticidesToxicoKinetic–ToxicoDynamic model (TKTD)

Substances

Pesticides

Authors and institutions

  • Wageningen University and Research, Wageningen, The Netherlands.
  • Institute for Biological Analysis and Consulting, Roßdorf, Germany.
  • Research & Development, Crop Science Terrestrial Invertebrates & Bees, Bayer CropScience, Monheim, Germany.

Funding

  • Bayer CropScience

Cite

APA

Baas, J., Goussen, B., Taenzler, V., Roeben, V., Miles, M., Preuss, T. G., van den Berg, S., & Roessink, I. (2024). Comparing Sensitivity of Different Bee Species to Pesticides: A TKTD modeling approach. Environmental Toxicology and Chemistry, 43(6), 1431-1441. https://doi.org/10.1002/etc.5871

Vancouver

Baas J, Goussen B, Taenzler V, Roeben V, Miles M, Preuss TG, et al. Comparing Sensitivity of Different Bee Species to Pesticides: A TKTD modeling approach. Environmental Toxicology and Chemistry. 2024;43(6):1431-1441. doi:10.1002/etc.5871

BibTeX
@article{Baas2024,
  author = {Baas, Jan and Goussen, Benoit and Taenzler, Verena and Roeben, Vanessa and Miles, Mark and Preuss, Thomas G and van den Berg, Sanne and Roessink, Ivo},
  title = {Comparing Sensitivity of Different Bee Species to Pesticides: A TKTD modeling approach},
  journal = {Environmental Toxicology and Chemistry},
  year = {2024},
  volume = {43},
  number = {6},
  pages = {1431--1441},
  doi = {10.1002/etc.5871}
}
Start for free →