EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Theoretical and Experimental Research on the Forming Process of Tube by the Tandem Skew Rolling Process

Feilong Mao, Jianguo Liang, Yuanhua Shuang, Fujie Wang, Jianhua Hu, Bo Wang

Engineering Reports · 2026-07 · 8 (7)

DOI: 10.1002/eng2.70972 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering Reports, online erschienen am 25.07.2026. Verfasst von Feilong Mao und 5 weiteren Autor:innen. Die Arbeit nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To investigate the forming mechanisms and force conditions of a tube blank during tandem skew rolling (TSR), force analysis diagrams were created for each stage of the process. Force equilibrium and rotation conditions for the forming coordination of each rolling stage were calculated and obtained. The finite element method (FEM) and experimental research method were used, and four groups of process parameters were designed for the comparative analysis. The finite element simulations reveal the deformation characteristics of the tube during the rolling process, and provide a reference for the experiment. The results showed that Groups 1 and 3 successfully completed the rolling process, resulting in hollow tubes with good surface quality. Compared to Group 1, the torsion observed in Group 2 is caused by a decrease in the roll gap of the rolling section, which reduces the volume of the metal passing through the rolling section. In comparison to Group 3, the tensile cracking observed in Group 4 was attributed to an increase in the roll rotational speed of the rolling section, which accelerated the axial metal flow and caused overtension in the piercing section. Further analysis of the rolling force curves from Group 3 revealed that the rolling force on the entry side of the piercing section rollers was greater than that on the exit side. From the analysis of the structure and tensile mechanical property, the fiber structures of Groups 1 and 3 are consisting of ferrite and pearlite, while the finer microstructure of Group3 corresponds to a higher yield strength and tensile strength.

Förderung

  • National Natural Science Foundation of China

Zitieren

APA

Mao, F., Liang, J., Shuang, Y., Wang, F., Hu, J., & Wang, B. (2026). Theoretical and Experimental Research on the Forming Process of Tube by the Tandem Skew Rolling Process. Engineering Reports, 8(7). https://doi.org/10.1002/eng2.70972

Vancouver

Mao F, Liang J, Shuang Y, Wang F, Hu J, Wang B. Theoretical and Experimental Research on the Forming Process of Tube by the Tandem Skew Rolling Process. Engineering Reports. 2026;8(7). doi:10.1002/eng2.70972

BibTeX
@article{Mao2026,
  author = {Mao, Feilong and Liang, Jianguo and Shuang, Yuanhua and Wang, Fujie and Hu, Jianhua and Wang, Bo},
  title = {Theoretical and Experimental Research on the Forming Process of Tube by the Tandem Skew Rolling Process},
  journal = {Engineering Reports},
  year = {2026},
  volume = {8},
  number = {7},
  doi = {10.1002/eng2.70972}
}
Kostenlos starten →