EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

pH and conductivity transients during elution of IgG from protein A columns

Rainer Hahn iD, Lukas Berger, Jürgen Beck, Giorgio Carta

Biotechnology Progress · 2025

DOI: 10.1002/btpr.3534 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Biotechnology Progress, 2025. Verfasst von Rainer Hahn und 3 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Bioprocess Science and Engineering, Department of Biotechnology, BOKU University, Vienna, Austria. Hauptthemen laut MEDLINE: Immunoglobulin G, Staphylococcal Protein A. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 41 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The evolution of pH and conductivity waves during elution of IgG from protein A columns is studied for the resin MabSelect PrismA as well as other commercial resins using glycine and acetate buffers as eluents. The effects of buffer composition, IgG load, and residence time are explored. For glycine buffers, conductivity and pH waves travel through the column at different speeds, with the conductivity wave emerging in the column void volume and the pH waves emerging in 1 to 6 column volumes (CV) dependent on the buffer composition. The pH effluent temporarily overshoots the feed value, followed by a sharp drop as the pH approaches the eluent pH. For these conditions, elution of IgG is delayed and, at high loads, most of the IgG loaded elutes from the column at high pH values. Complex pH profiles, involving overshoots and delays between conductivity and pH waves are also observed when eluting with dilute sodium acetate (50 mM) or with acetic acid, but to a lesser extent. No overshoots or delays are observed for more concentrated sodium acetate (100 mM). A mechanistic model is developed to predict elution with glycine buffers. Model predictions agree with the experimental trends. In particular, the model shows that when eluting a partially loaded column, IgG desorbed near the column entrance is re‐adsorbed downstream of the pH front eventually emerging at high concentration and high pH. The model can be used to design optimized buffers and predict the pH of the IgG elution pool.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Immunoglobulin GStaphylococcal Protein AHydrogen-Ion ConcentrationElectric ConductivityGlycineBuffers

Stichwörter der Autor:innen

IgGmodelingpH transientsprotein a columns

Substanzen

Immunoglobulin GStaphylococcal Protein AGlycineBuffers

Autor:innen und Institutionen

  • Institute of Bioprocess Science and Engineering, Department of Biotechnology, BOKU University, Vienna, Austria.
  • Department of Chemical Engineering, University of Virginia, Charlottesville, Virginia, USA.

ORCID-Profile: Rainer Hahn

Zitieren

APA

Hahn, R., Berger, L., Beck, J., & Carta, G. (2025). pH and conductivity transients during elution of IgG from protein A columns. Biotechnology Progress. https://doi.org/10.1002/btpr.3534

Vancouver

Hahn R, Berger L, Beck J, Carta G. pH and conductivity transients during elution of IgG from protein A columns. Biotechnology Progress. 2025. doi:10.1002/btpr.3534

BibTeX
@article{Hahn2025,
  author = {Hahn, Rainer and Berger, Lukas and Beck, Jürgen and Carta, Giorgio},
  title = {pH and conductivity transients during elution of IgG from protein A columns},
  journal = {Biotechnology Progress},
  year = {2025},
  doi = {10.1002/btpr.3534}
}
Kostenlos starten →