EUVIMEDOpdag EUVIMED
Open access · CC BY-NC 4.0

Injection molding of biodegradable polyester blends filled with mineral and sustainable fillers: Performance evaluation

Dayna Colleen McNeill, Akhilesh Kumar Pal, Amar K. Mohanty, Manjusri Misra

Journal of Applied Polymer Science · 2024-04-05 · 141 (13)

DOI: 10.1002/app.55166 ↗

At a glance

Journal article in Journal of Applied Polymer Science, 2024-02. Written by Dayna Colleen McNeill and 3 co-authors. Cited 18 times so far (Crossref); 69 references. The full text is freely available (open access, CC BY-NC 4.0). Funded by: Natural Sciences and Engineering Research Council of Canada.

AbstractBibliografiske oplysningerCiteRelated studies

Abstract (original language)

This research focuses on the melt processing of biocomposites from a biodegradable polymer blend mixed with hybrid fillers through injection molding technique. An optimized blend ratio (60/40 wt%) poly(butylene succinate‐co‐butylene adipate) (PBSA) and poly(butylene adipate‐co‐terephthalate) (PBAT) demonstrated promising results after blending with a mixture of walnut shell powder (WSP), corn starch and talc in various proportions for use in rigid packaging. The addition of hybrid fillers (i) 10% WSP with 15% talc and (ii) 5% WSP with 5% starch and 15% talc to the polymer blend (60%PBSA/40%PBAT) improved tensile modulus (160% and 162%, respectively) and flexural modulus (147% and 153%, respectively) because of the dispersion of stiffer talc and WSP. Following the addition of fillers, tensile strength of the composites decreased. However, flexural strength improved significantly after filler introduction because of better stress transfer ability. Rheological analysis of filled composites with starch or WSP (25%) depicted similar characteristics of the polymer blend, indicating lower viscosity than hybrid composites. The abundant hydroxyl groups in starch explained the increased water absorption and decreased contact angle compared with other composites. This research's novelty encompasses utilizing low‐cost biomasses with mineral filler into an under‐researched biodegradable polymer blend suitable for single‐use rigid packaging applications.

Funding

  • Natural Sciences and Engineering Research Council of Canada

Cite

APA

McNeill, D. C., Pal, A. K., Mohanty, A. K., & Misra, M. (2024). Injection molding of biodegradable polyester blends filled with mineral and sustainable fillers: Performance evaluation. Journal of Applied Polymer Science, 141(13). https://doi.org/10.1002/app.55166

Vancouver

McNeill DC, Pal AK, Mohanty AK, Misra M. Injection molding of biodegradable polyester blends filled with mineral and sustainable fillers: Performance evaluation. Journal of Applied Polymer Science. 2024;141(13). doi:10.1002/app.55166

BibTeX
@article{McNeill2024,
  author = {McNeill, Dayna Colleen and Pal, Akhilesh Kumar and Mohanty, Amar K. and Misra, Manjusri},
  title = {Injection molding of biodegradable polyester blends filled with mineral and sustainable fillers: Performance evaluation},
  journal = {Journal of Applied Polymer Science},
  year = {2024},
  volume = {141},
  number = {13},
  doi = {10.1002/app.55166}
}
Start for free →