3D Printed Multimaterial Microfluidic Transistors
Advanced Materials Technologies · 2026-05 · 11 (10)
DOI: 10.1002/admt.202501509 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Materials Technologies, online erschienen am 06.03.2026. Verfasst von Alireza Ahmadianyazdi und 7 weiteren Autor:innen. Die Arbeit nennt 87 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Institute of General Medical Sciences, National Cancer Institute, National Institutes of Health.
Abstract (Originalsprache)
Microfluidic actuators, including elastomeric microvalves and microfluidic transistors, are increasingly used to augment and simplify flow automation. The vast majority of these actuators regulate flow using microfabricated, thin membranes that are inherently difficult to fabricate and integrate into small devices. The performance of these actuator platforms is critically determined by the membrane's mechanical performance, which calls for scalable and reliable membrane microfabrication techniques. Previous approaches for manufacturing elastomeric membranes in microfluidic actuators enabled either their high‐resolution fabrication (e.g., soft lithography) or their facile manufacturability (e.g., 3D printing), but not both. Here we present a photopolymer resin that closely mimics the Young's Modulus (elasticity) and reversible stretchability (no hysteresis) of poly(dimethylsiloxane) (PDMS) without compromising its high resolution or biocompatibility. This development enables the fabrication of microfluidic transistors (i.e., microvalves capable of proportional amplification) by multimaterial stereolithography (mSLA). Our mSLA‐printed microfluidic transistors display proportional pressure amplification occasionally reaching large intrinsic gains (>300), although reliably printing complex multi‐transistor devices will require high‐resolution 3D‐printers. Moreover, the absence of hysteresis overcomes a longstanding problem of unequal opening and closing thresholds found in most microfluidic actuators, allowing us to demonstrate the first mSLA‐printed pressure amplifiers. This work represents an advancement toward building more complex microfluidic automats.
Förderung
- National Institute of General Medical Sciences
- National Cancer Institute
- National Institutes of Health
- National Science and Technology Council
Zitieren
APA
Ahmadianyazdi, A., Huang, W., Gopinathan, K. A., Stepanov, I., Horowitz, L., Tu, T., Toner, M., & Folch, A. (2026). 3D Printed Multimaterial Microfluidic Transistors. Advanced Materials Technologies, 11(10). https://doi.org/10.1002/admt.202501509
Vancouver
Ahmadianyazdi A, Huang W, Gopinathan KA, Stepanov I, Horowitz L, Tu T, et al. 3D Printed Multimaterial Microfluidic Transistors. Advanced Materials Technologies. 2026;11(10). doi:10.1002/admt.202501509
BibTeX
@article{Ahmadianyazdi2026,
author = {Ahmadianyazdi, Alireza and Huang, Wei and Gopinathan, Kaustav A. and Stepanov, Ivan and Horowitz, Lisa and Tu, Ting‐Yuan and Toner, Mehmet and Folch, Albert},
title = {3D Printed Multimaterial Microfluidic Transistors},
journal = {Advanced Materials Technologies},
year = {2026},
volume = {11},
number = {10},
doi = {10.1002/admt.202501509}
}
EUVIMED