Strain‐Driven Negative Resistance Switching of Conductive Fibers with Adjustable Sensitivity for Wearable Healthcare Monitoring Systems with Near‐Zero Standby Power
Advanced Materials · 2023-09 · 35 (36)
DOI: 10.1002/adma.202303556 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Materials, online erschienen am 19.07.2023. Verfasst von Won Kyung Min und 7 weiteren Autor:innen. Beteiligte Einrichtung: Electronic Device Laboratory, School of Electrical and Electronic Engineering, Yonsei University, 50 Yonsei-ro, Seodaemun-gu, Seoul, 03722, Republic …. Hauptthemen laut MEDLINE: Wearable Electronic Devices. Die Arbeit wurde bisher 33-mal zitiert (Crossref) und nennt 47 Literaturangaben. Gefördert von: National Research Foundation of Korea, Priority Research Centers Program, ICONS (Institute of Convergence Science) in Yonsei University.
Abstract (Originalsprache)
Recently, one of the primary concerns in e‐textile‐based healthcare monitoring systems for chronic illness patients has been reducing wasted power consumption, as the system should be always‐on to capture diverse biochemical and physiological characteristics. However, the general conductive fibers, a major component of the existing wearable monitoring systems, have a positive gauge‐factor (GF) that increases electrical resistance when stretched, so that the systems have no choice but to consume power continuously. Herein, a twisted conductive‐fiber‐based negatively responsive switch‐type (NRS) strain‐sensor with an extremely high negative GF (resistance change ratio ≈ 3.9 × 10 8 ) that can significantly increase its conductivity from insulating to conducting properties is developed. To this end, a precision cracking technology is devised, which could induce a difference in the Young's modulus of the encapsulated layer on the fiber through selective ultraviolet‐irradiation treatment. Owing to this technology, the NRS strain‐sensors can allow for effective regulation of the mutual contact resistance under tensile strain while maintaining superior durability for over 5000 stretching cycles. For further practical demonstrations, three healthcare monitoring systems (E‐fitness pants, smart‐masks, and posture correction T‐shirts) with near‐zero standby power are also developed, which opens up advancements in electronic textiles by expanding the utilization range of fiber strain‐sensors.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Electronic Device Laboratory, School of Electrical and Electronic Engineering, Yonsei University, 50 Yonsei-ro, Seodaemun-gu, Seoul, 03722, Republic of Korea.
- Nanobio Device Laboratory, School of Electrical and Electronic Engineering, Yonsei University, 50 Yonsei-ro, Seodaemun-gu, Seoul, 03722, Republic of Korea.
- KIURI Institute, Yonsei University, 50 Yonsei-ro, Seodaemun-gu, Seoul, 03722, Republic of Korea.
- BIT Micro Fab Research Center, Yonsei University, 50 Yonsei-ro, Seodaemun-gu, Seoul, 03722, Republic of Korea.
ORCID-Profile: Hyun Jae Kim
Förderung
- National Research Foundation of Korea
- Priority Research Centers Program
- ICONS (Institute of Convergence Science) in Yonsei University
Zitieren
APA
Min, W. K., Won, C., Kim, D. H., Lee, S., Chung, J., Cho, S., Lee, T., & Kim, H. J. (2023). Strain‐Driven Negative Resistance Switching of Conductive Fibers with Adjustable Sensitivity for Wearable Healthcare Monitoring Systems with Near‐Zero Standby Power. Advanced Materials, 35(36). https://doi.org/10.1002/adma.202303556
Vancouver
Min WK, Won C, Kim DH, Lee S, Chung J, Cho S, et al. Strain‐Driven Negative Resistance Switching of Conductive Fibers with Adjustable Sensitivity for Wearable Healthcare Monitoring Systems with Near‐Zero Standby Power. Advanced Materials. 2023;35(36). doi:10.1002/adma.202303556
BibTeX
@article{Min2023,
author = {Min, Won Kyung and Won, Chihyeong and Kim, Dong Hyun and Lee, Sanghyeon and Chung, Jusung and Cho, Sungjoon and Lee, Taeyoon and Kim, Hyun Jae},
title = {Strain‐Driven Negative Resistance Switching of Conductive Fibers with Adjustable Sensitivity for Wearable Healthcare Monitoring Systems with Near‐Zero Standby Power},
journal = {Advanced Materials},
year = {2023},
volume = {35},
number = {36},
doi = {10.1002/adma.202303556}
}
EUVIMED