Direct Ink Write 3D Printing of Fully Dense and Functionally Graded Liquid Metal Elastomer Foams
Advanced Functional Materials · 2024-11 · 34 (46)
DOI: 10.1002/adfm.202410908 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Functional Materials, online erschienen am 06.09.2024. Verfasst von Spencer Pak und 2 weiteren Autor:innen. Die Arbeit wurde bisher 25-mal zitiert (Crossref) und nennt 58 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Division of Civil, Mechanical and Manufacturing Innovation, Nebraska Space Grant Consortium, Division of Electrical, Communications and Cyber Systems.
Abstract (Originalsprache)
Liquid metal (LM) elastomer composites offer promising potential in soft robotics, wearable electronics, and human‐machine interfaces. Direct ink write (DIW) 3D printing offers a versatile manufacturing technique capable of precise control over LM microstructures, yet challenges such as interfilament void formation in multilayer structures impact material performance. Here, a DIW strategy is introduced to control both LM microstructure and material architecture. Investigating three key process parameters–nozzle height, extrusion rate, and nondimensionalized nozzle velocity–it is found that nozzle height and velocity predominantly influence filament geometry. The nozzle height primarily dictates the aspect ratio of the filament and the formation of voids. A threshold print height based on filament geometry is identified; below the height, significant surface roughness occurs, and above the ink fractures, which facilitates the creation of porous structures with tunable stiffness and programmable LM microstructure. These porous architectures exhibit reduced density and enhanced thermal conductivity compared to cast samples. When used as a dielectric in a soft capacitive sensor, they display high sensitivity (gauge factor = 9.0), as permittivity increases with compressive strain. These results demonstrate the capability to simultaneously manipulate LM microstructure and geometric architecture in LM elastomer composites through precise control of print parameters, while maintaining geometric fidelity in the printed design.
Förderung
- Division of Civil, Mechanical and Manufacturing Innovation
- Nebraska Space Grant Consortium
- Division of Electrical, Communications and Cyber Systems
Zitieren
APA
Pak, S., Bartlett, M. D., & Markvicka, E. J. (2024). Direct Ink Write 3D Printing of Fully Dense and Functionally Graded Liquid Metal Elastomer Foams. Advanced Functional Materials, 34(46). https://doi.org/10.1002/adfm.202410908
Vancouver
Pak S, Bartlett MD, Markvicka EJ. Direct Ink Write 3D Printing of Fully Dense and Functionally Graded Liquid Metal Elastomer Foams. Advanced Functional Materials. 2024;34(46). doi:10.1002/adfm.202410908
BibTeX
@article{Pak2024,
author = {Pak, Spencer and Bartlett, Michael D. and Markvicka, Eric J.},
title = {Direct Ink Write 3D Printing of Fully Dense and Functionally Graded Liquid Metal Elastomer Foams},
journal = {Advanced Functional Materials},
year = {2024},
volume = {34},
number = {46},
doi = {10.1002/adfm.202410908}
}
EUVIMED