Polysiloxane Inks for Multimaterial 3d Printing of High‐Permittivity Dielectric Elastomers
Advanced Functional Materials · 2024-04 · 34 (17)
DOI: 10.1002/adfm.202313167 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Functional Materials, online erschienen am 27.12.2023. Verfasst von Patrick M. Danner und 6 weiteren Autor:innen. Die Arbeit wurde bisher 32-mal zitiert (Crossref) und nennt 52 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Board of the Swiss Federal Institutes of Technology, HORIZON EUROPE European Research Council.
Abstract (Originalsprache)
Dielectric elastomer transducers (DET) are promising candidates for electrically‐driven soft robotics. However, the high viscosity and low yield stress of DET formulations prohibit 3D printing, the most common manufacturing method for designer soft actuators. DET inks optimized for direct ink writing (DIW) produce elastomers with high stiffness and mechanical losses, diminishing the utility of DET actuators. To address the antagonistic nature of processing and performance constraints, principles of capillary suspensions are used to engineer DIW DET inks. By blending two immiscible polysiloxane liquids with a filler, a capillary ink suspension is obtained, in which the ink rheology can be tuned independently of the elastomer electromechanical properties. Rheometry is performed to measure and optimize processibility as a function of filler and secondary liquid fraction. Including polar polysiloxanes as the secondary liquid produces a printed elastomer exhibiting a four‐fold permittivity increase over commercial polydimethylsiloxane. The characterization and multimaterial printing into layered DET devices demonstrates that the immiscible capillary suspension improves the processability of the inks and enhances the properties of the elastomers, enabling actuation of the devices at comparatively low voltages. It is anticipated that this formulation approach will allow soft robotics to harness the full potential of DETs.
Förderung
- Board of the Swiss Federal Institutes of Technology
- HORIZON EUROPE European Research Council
Zitieren
APA
Danner, P. M., Pleij, T., Siqueira, G., Bayles, A. V., Venkatesan, T. R., Vermant, J., & Opris, D. M. (2024). Polysiloxane Inks for Multimaterial 3d Printing of High‐Permittivity Dielectric Elastomers. Advanced Functional Materials, 34(17). https://doi.org/10.1002/adfm.202313167
Vancouver
Danner PM, Pleij T, Siqueira G, Bayles AV, Venkatesan TR, Vermant J, et al. Polysiloxane Inks for Multimaterial 3d Printing of High‐Permittivity Dielectric Elastomers. Advanced Functional Materials. 2024;34(17). doi:10.1002/adfm.202313167
BibTeX
@article{Danner2024,
author = {Danner, Patrick M. and Pleij, Tazio and Siqueira, Gilberto and Bayles, Alexandra V. and Venkatesan, Thulasinath Raman and Vermant, Jan and Opris, Dorina M.},
title = {Polysiloxane Inks for Multimaterial 3d Printing of High‐Permittivity Dielectric Elastomers},
journal = {Advanced Functional Materials},
year = {2024},
volume = {34},
number = {17},
doi = {10.1002/adfm.202313167}
}
EUVIMED