EUVIMEDEUVIMED entdecken
Crossref

Microstructural Inhomogeneity Complicates Small‐Scale Fracture Toughness Testing of Ceramic Nanocomposites

Douglas Steinbach, Xing Liu, Boyu Zhang, Aleksandar Mijailovic, Rodolfo Cantu, Christos E. Athanasiou, Cristina Ramirez, Xing Wang, Izabela Szlufarska, Nitin P. Padture, Brian W. Sheldon, Jun Lou

Advanced Engineering Materials · 17.11.2026

DOI: 10.1002/adem.71425 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Engineering Materials, online erschienen am 17.11.2026. Verfasst von Douglas Steinbach und 11 weiteren Autor:innen. Die Arbeit nennt 42 Literaturangaben. Gefördert von: Basic Energy Sciences.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Ion‐implantation effects in ceramics and composites are surface‐localized to a few microns. Therefore, measurements of the mechanical properties, such as fracture toughness, of ion‐implanted ceramics and composites necessitate the use of microscopic specimens. While techniques such as microcantilever beam bending and micropillar splitting are often used to test microscopic specimens, critically comparing the results from these two techniques is important. Here, the micropillar splitting technique was used to measure the fracture toughness of monolithic SiC (1.94 ± 0.27 MPa·m 1/2 ) and carbon nanotubes (CNTs)‐reinforced SiC nanocomposites before and after C 2+ ion implantation. These results are compared with fracture toughness values previously measured for the same materials using the microcantilever beam bending technique. There is good agreement between the fracture toughness of monolithic SiC measured by micropillar splitting and microcantilever beam bending (~1.94 vs. ~2.42 MPa·m 1/2 , respectively, for the nonirradiated condition), as well as with literature values. However, the fracture toughness of the nanocomposites measured by the micropillar‐splitting technique was consistently lower than that obtained by microcantilever beam bending, both under nonirradiated conditions (~0.99 vs. ~2.70 MPa·m 1/2 , respectively) and after irradiation (~1.55 vs. ~4.76 MPa·m 1/2 , respectively). This difference was attributed to the pronounced microstructural inhomogeneity resulting from CNT addition and ion implantation.

Förderung

  • Basic Energy Sciences

Zitieren

APA

Steinbach, D., Liu, X., Zhang, B., Mijailovic, A., Cantu, R., Athanasiou, C. E., Ramirez, C., Wang, X., Szlufarska, I., Padture, N. P., Sheldon, B. W., & Lou, J. (2026). Microstructural Inhomogeneity Complicates Small‐Scale Fracture Toughness Testing of Ceramic Nanocomposites. Advanced Engineering Materials. https://doi.org/10.1002/adem.71425

Vancouver

Steinbach D, Liu X, Zhang B, Mijailovic A, Cantu R, Athanasiou CE, et al. Microstructural Inhomogeneity Complicates Small‐Scale Fracture Toughness Testing of Ceramic Nanocomposites. Advanced Engineering Materials. 2026. doi:10.1002/adem.71425

BibTeX
@article{Steinbach2026,
  author = {Steinbach, Douglas and Liu, Xing and Zhang, Boyu and Mijailovic, Aleksandar and Cantu, Rodolfo and Athanasiou, Christos E. and Ramirez, Cristina and Wang, Xing and Szlufarska, Izabela and Padture, Nitin P. and Sheldon, Brian W. and Lou, Jun},
  title = {Microstructural Inhomogeneity Complicates Small‐Scale Fracture Toughness Testing of Ceramic Nanocomposites},
  journal = {Advanced Engineering Materials},
  year = {2026},
  doi = {10.1002/adem.71425}
}
Kostenlos starten →