Multiscale Modeling of Process‐Induced Defects in Fused Filament Fabrication‐Printed Materials
Advanced Engineering Materials · 2025-10 · 27 (20)
DOI: 10.1002/adem.202402592 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Engineering Materials, online erschienen am 10.08.2025. Verfasst von Satyajit Mojumder und 3 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 52 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Process‐induced defects are inherent to additively manufactured parts and significantly influence the performance of printed materials. This article introduces a predictive performance modeling framework for defect analysis in fused filament fabrication (FFF)‐printed materials, leveraging a mechanistic data science‐based reduced‐order modeling (ROM) approach. The proposed model addresses process‐induced variabilities by quantifying defects across micro‐ and mesoscales and integrating them into part‐scale performance predictions. Employing mechanistic ROM enables concurrent multiscale modeling of FFF‐printed materials, explicitly accounting for local microstructures and defects. A thermoelastic extension of the mechanistic ROM is introduced to evaluate the thermal residual stresses developed during the FFF process. Applying the mechanistic ROM framework, defects in FFF‐printed polylactic acid (PLA) and PLA with short carbon fiber (PLA/SCF) composites are analyzed to establish a multiscale model for predicting the mechanical performance of tensile and three‐point bending specimens. The results highlight that accurate material performance prediction relies on capturing process‐induced defects, with the mechanistic ROM successfully simulating behavior across both local and part‐scale domains. The proposed defect analysis and modeling approach can be extended to other additive manufacturing processes to offer valuable insights into microstructure‐guided material design.
Zitieren
APA
Mojumder, S., Suarez, D., Abbott, T., & Liu, W. K. (2025). Multiscale Modeling of Process‐Induced Defects in Fused Filament Fabrication‐Printed Materials. Advanced Engineering Materials, 27(20). https://doi.org/10.1002/adem.202402592
Vancouver
Mojumder S, Suarez D, Abbott T, Liu WK. Multiscale Modeling of Process‐Induced Defects in Fused Filament Fabrication‐Printed Materials. Advanced Engineering Materials. 2025;27(20). doi:10.1002/adem.202402592
BibTeX
@article{Mojumder2025,
author = {Mojumder, Satyajit and Suarez, Derick and Abbott, Trevor and Liu, Wing Kam},
title = {Multiscale Modeling of Process‐Induced Defects in Fused Filament Fabrication‐Printed Materials},
journal = {Advanced Engineering Materials},
year = {2025},
volume = {27},
number = {20},
doi = {10.1002/adem.202402592}
}
EUVIMED