EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Detector response and dose calculation lateral to material interfaces for 6 MV photon beam

Jonas Ringholz iD, Otto Andreas Sauer, Sonja Wegener iD

Journal of Applied Clinical Medical Physics · 2025

DOI: 10.1002/acm2.70302 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Applied Clinical Medical Physics, 2025. Verfasst von Jonas Ringholz und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Radiation Oncology, University Hospital Würzburg, Würzburg, Germany. Hauptthemen laut MEDLINE: Radiotherapy Planning, Computer-Assisted, Photons, Algorithms, Phantoms, Imaging. Die Arbeit nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Background

Dose calculation around inhomogeneities is challenging for many algorithms. A validation of dose distributions in these conditions is not straightforward, as detector response close to material interfaces is affected by the non‐equilibrium situation, the changing energy spectrum and the volume effect in a steep dose gradient.

Purpose

Detector response lateral to an inhomogeneity of high density was studied, mimicking the situation of bone surrounded by soft tissue.

Methods

Profiles obtained with different detectors (diodes, ion chamber, synthetic diamond) in water in the vicinity of an aluminum cylinder were compared. Dose deposition was also calculated with different commercial treatment planning systems and algorithms as well as using Monte Carlo simulations within and lateral to the cylinder and compared to measurements.

Results

Dose deposition in the vicinity of an inserted aluminum cylinder changes and is registered by the detectors to a different degree. The ion chamber shows the largest change irradiated with a 10×10 cm 2 at 3 mm distance from the cylinder surface (2.5%), followed by the synthetic diamond (1.7%), then the unshielded (1.4%) and finally the shielded diode (1.0%). Dose calculated by different commercial dose engines differed up to 3% at that point from the detector values (Collapsed Cone).

Conclusions

Dose calculation near inhomogeneities depends on the used algorithm, dose measurements in the same region differ depending on the detector type used. We recommend verification of dose calculation with second type of algorithm and measurements with at least two detector types.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Radiotherapy Planning, Computer-AssistedPhotonsAlgorithmsPhantoms, ImagingRadiometryHumansMonte Carlo MethodRadiotherapy DosageRadiotherapy, Intensity-ModulatedParticle Accelerators

Stichwörter der Autor:innen

detector responsedose calculationinhomogeneities

Autor:innen und Institutionen

  • Department of Radiation Oncology, University Hospital Würzburg, Würzburg, Germany.

ORCID-Profile: Jonas Ringholz, Sonja Wegener

Zitieren

APA

Ringholz, J., Sauer, O. A., & Wegener, S. (2025). Detector response and dose calculation lateral to material interfaces for 6 MV photon beam. Journal of Applied Clinical Medical Physics. https://doi.org/10.1002/acm2.70302

Vancouver

Ringholz J, Sauer OA, Wegener S. Detector response and dose calculation lateral to material interfaces for 6 MV photon beam. Journal of Applied Clinical Medical Physics. 2025. doi:10.1002/acm2.70302

BibTeX
@article{Ringholz2025,
  author = {Ringholz, Jonas and Sauer, Otto Andreas and Wegener, Sonja},
  title = {Detector response and dose calculation lateral to material interfaces for 6 MV photon beam},
  journal = {Journal of Applied Clinical Medical Physics},
  year = {2025},
  doi = {10.1002/acm2.70302}
}
Kostenlos starten →