The influence of shot peening on the stress state in the adhesive layer and the load capacity of adhesive joints
Technologia i Automatyzacja Montażu · 2022
DOI: 10.7862/tiam.2022.2.5 ↗Kurz gefasst
Fachartikel in der Zeitschrift Technologia i Automatyzacja Montażu, 2022. Verfasst von Władysław Zielecki und 2 weiteren Autor:innen.
Abstract (Originalsprache)
The aim of the article was to determine the influence of shot peening of the outer surface of the overlap on the stress state in the adhesive layer and the load capacity of single lap adhesive joints made of EN AW-2024-T3 aluminum alloy. Experimental investigations and numerical simulations were carried out. According to the results of experimental analyses, shot peening with balls with a diameter of 1 mm for 120 s with a compressed air pressure of 0.5 MPa increased the load capacity of the adhesive joints by 33%. Numerical simulations have shown that shot peening, by deforming the joined elements, reduces the stress perpendicular to the surface of the adhesive layer which results in a reduction of equivalent (von Misses) stress and an increase in strength of adhesive joints.
Zitieren
APA
Zielecki, W., Godzimirski, J., & Ozga, E. (2022). The influence of shot peening on the stress state in the adhesive layer and the load capacity of adhesive joints. Technologia i Automatyzacja Montażu. https://doi.org/10.7862/tiam.2022.2.5
Vancouver
Zielecki W, Godzimirski J, Ozga E. The influence of shot peening on the stress state in the adhesive layer and the load capacity of adhesive joints. Technologia i Automatyzacja Montażu. 2022. doi:10.7862/tiam.2022.2.5
BibTeX
@article{Zielecki2022,
author = {Zielecki, Władysław and Godzimirski, Jan and Ozga, Ewelina},
title = {The influence of shot peening on the stress state in the adhesive layer and the load capacity of adhesive joints},
journal = {Technologia i Automatyzacja Montażu},
year = {2022},
doi = {10.7862/tiam.2022.2.5}
}
EUVIMED