EUVIMEDEUVIMED entdecken
Crossref

Effect of forming parameters on the fracture behaviour of AISI 430 steel in draw-bend fracture test

Valmir Dias Luiz, Almir Silva Neto, Wilian da Silva Labiapari, Paulo César de Matos Rodrigues

Advances in Mechanical and Materials Engineering · 2026 · 43 (1) · 127-138

DOI: 10.7862/rm.2026.9 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advances in Mechanical and Materials Engineering, 2026. Verfasst von Valmir Dias Luiz und 3 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The draw-bend fracture (DBF) test was used to simulate the different forming conditions of AISI 430 steel strips with thickness of 0.8 mm. The tests were performed for varying test parameters such tool radius, drawing speed and strip orientation. The analysis of variance (ANOVA) at α = 0.05 significance level was used to determine the relationship between the test parameters and the major strain, the total elongation and the thickness reduction of samples as well as the coefficient of friction. A comparative analysis of the DBF test results revealed that parameters related to specimen deformation changed with an increasing tool radius to thickness (R/t) ratio. However, no statistically significant effect of drawing speed or strip orientation on major strain and thickness reduction was observed. The value of total elongation increased with increasing R/t ratio. An increase in drawing speed resulted, for both analyzed strip orientations, in a reduction of the coefficient of friction. Over the entire range of analyzed sliding speeds and R/t ratios, the coefficient of friction for sheets oriented along the sheet rolling direction was higher than that for specimens cut in the transverse direction.

Zitieren

APA

Luiz, V. D., Neto, A. S., Labiapari, W. D. S., & Rodrigues, P. C. D. M. (2026). Effect of forming parameters on the fracture behaviour of AISI 430 steel in draw-bend fracture test. Advances in Mechanical and Materials Engineering, 43(1), 127-138. https://doi.org/10.7862/rm.2026.9

Vancouver

Luiz VD, Neto AS, Labiapari WDS, Rodrigues PCDM. Effect of forming parameters on the fracture behaviour of AISI 430 steel in draw-bend fracture test. Advances in Mechanical and Materials Engineering. 2026;43(1):127-138. doi:10.7862/rm.2026.9

BibTeX
@article{Luiz2026,
  author = {Luiz, Valmir Dias and Neto, Almir Silva and Labiapari, Wilian da Silva and Rodrigues, Paulo César de Matos},
  title = {Effect of forming parameters on the fracture behaviour of AISI 430 steel in draw-bend fracture test},
  journal = {Advances in Mechanical and Materials Engineering},
  year = {2026},
  volume = {43},
  number = {1},
  pages = {127--138},
  doi = {10.7862/rm.2026.9}
}
Kostenlos starten →