TDOA/DOA hybrid location method of partial discharge combined with blind signal separation algorithm
Acta Physica Sinica · 2025 · 74 (13) · 135207
DOI: 10.7498/aps.74.20250317 ↗Kurz gefasst
Fachartikel in der Zeitschrift Acta Physica Sinica, 2025. Verfasst von Zeyu ZHANG und 4 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 32 Literaturangaben.
Abstract (Originalsprache)
To address the technical bottleneck of decoupling spatiotemporal feature, high hardware costs, and high computational complexity in ultrasonic detection of partial discharge (PD) in electrical equipment, this paper proposes a TDOA/DOA hybrid localization method based on kernel principal component analysis (KPCA) and modified noncircular FastICA (mnc-FastICA). By integrating spatiotemporal feature extraction with intelligent optimization mechanisms, this method achieves high-precision localization by using a small-scale sensor array. The key innovations are as follows. First, a KPCA-assisted pseudo-whitening preprocessing framework is constructed by using polynomial kernel mapping for nonlinear signal dimensionality reduction, which preserves the correlation between time delay (TDOA) and direction-of-arrival (DOA) features while suppressing environmental noise. Second, after the blind separation of ultrasonic signals via the mnc-FastICA algorithm, TDOA/DOA parameters are synchronously extracted through a combination of the generalized cross-correlation (GCC) method and array manifold analysis. Finally, a maximum likelihood estimation model integrating dual parameters is established, and the African vulture optimization algorithm (AVOA) is introduced to accelerate global optimal solution convergence. Experimental results demonstrate that with a compact hardware configuration of two orthogonal arrays (8 sensors in total), the proposed method achieves a TDOA estimation error of 2.34%, DOA estimation accuracy better than 2°, and localization errors as low as 1.54 cm. This approach effectively resolves the discrepancies among spatiotemporal feature coupling, hardware cost, and localization accuracy in PD detection, providing a novel solution for condition monitoring of electrical equipment.
Zitieren
APA
ZHANG, Z., TANG, X., LI, X., LIU, C., & ZHOU, J. (2025). TDOA/DOA hybrid location method of partial discharge combined with blind signal separation algorithm. Acta Physica Sinica, 74(13), 135207. https://doi.org/10.7498/aps.74.20250317
Vancouver
ZHANG Z, TANG X, LI X, LIU C, ZHOU J. TDOA/DOA hybrid location method of partial discharge combined with blind signal separation algorithm. Acta Physica Sinica. 2025;74(13):135207. doi:10.7498/aps.74.20250317
BibTeX
@article{ZHANG2025,
author = {ZHANG, Zeyu and TANG, Xiaojun and LI, Xiaoshan and LIU, Chongzhi and ZHOU, Jiahong},
title = {TDOA/DOA hybrid location method of partial discharge combined with blind signal separation algorithm},
journal = {Acta Physica Sinica},
year = {2025},
volume = {74},
number = {13},
pages = {135207},
doi = {10.7498/aps.74.20250317}
}
EUVIMED