EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Numerical analysis and geometric optimisation of tools for ceramic mass extrusion

Marek Hawryluk*, Jan Marzec, Konrad Perzyński, Łukasz Dudkiewicz, Bartosz Jóźwiak, Marek Wiergowski, Magdalena Lemiech, Jacek Michalczyk

Computer Methods in Materials Science · 2026 · 26 (2)

DOI: 10.7494/cmms.2026.2.1054 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Computer Methods in Materials Science, 2026. Verfasst von Marek Hawryluk* und 7 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The article presents a numerical analysis of the ceramic mass extrusion process and an assessment of the influence of the geometry of the tools’ inlet zone on their loading and service life. The rheological properties of the investigated ceramic mass were determined based on compression tests, while the friction conditions were evaluated using ring compression tests, yielding a friction coefficient of μ = 0.2. The extrusion process was modelled using the Abaqus 2024 software and the mesh-free smoothed particle hydrodynamics (SPH) method. The analysis considered the baseline geometry as well as variants incorporating fillets at the working edge with radii of R = 2.5 and 5 mm. The simulation results demonstrated a reduction in local stress concentrations and a more favourable stress distribution for the variant with a radius of R = 5 mm and an angle of 12°, which was selected for industrial verification. Measurements of tool wear after 170 h of operation, performed using 3D scanning, confirmed that the location of the maximum wear corresponded to the areas of elevated stresses identified by the model. The application of the modified geometry reduced the maximum material loss in the working-edge region from more than 1.67 mm to 1.30 mm, corresponding to a reduction in wear of more than 20%.

Zitieren

APA

Hawryluk*, M., Marzec, J., Perzyński, K., Dudkiewicz, Ł., Jóźwiak, B., Wiergowski, M., Lemiech, M., & Michalczyk, J. (2026). Numerical analysis and geometric optimisation of tools for ceramic mass extrusion. Computer Methods in Materials Science, 26(2). https://doi.org/10.7494/cmms.2026.2.1054

Vancouver

Hawryluk* M, Marzec J, Perzyński K, Dudkiewicz Ł, Jóźwiak B, Wiergowski M, et al. Numerical analysis and geometric optimisation of tools for ceramic mass extrusion. Computer Methods in Materials Science. 2026;26(2). doi:10.7494/cmms.2026.2.1054

BibTeX
@article{Hawryluk2026,
  author = {Hawryluk*, Marek and Marzec, Jan and Perzyński, Konrad and Dudkiewicz, Łukasz and Jóźwiak, Bartosz and Wiergowski, Marek and Lemiech, Magdalena and Michalczyk, Jacek},
  title = {Numerical analysis and geometric optimisation of tools for ceramic mass extrusion},
  journal = {Computer Methods in Materials Science},
  year = {2026},
  volume = {26},
  number = {2},
  doi = {10.7494/cmms.2026.2.1054}
}
Kostenlos starten →