Timber Bridge Pile Splicing with Traditional and Fiber Reinforced Polymer Wrap Methods
International Journal of Bridge Engineering, Management and Research · 10.04.2026 · 3 (2)
DOI: 10.70465/ber.v3i2.82 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal of Bridge Engineering, Management and Research, online erschienen am 10.04.2026. Verfasst von GangaRao Hota und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
Current timber pile splicing mechanisms utilize various steel, concrete, or wooden components. This study evaluated the strength capacities of steel and wood splicing mechanisms in addition to the FRP wrap splice mechanism. Splicing mechanisms studied herein are flat steel plate, C-Channel steel plate, wooden plate splices, and FRP wrap splices, consisting of unidirectional glass/epoxy composite with three and six layers of glass fabrics, which were reinforcing wooden components in both the longitudinal and hoop directions. These four splicing mechanisms were tested and compared under shear, bending, and axial loads. Of the three traditional splicing mechanisms excluding FRP wrap, the C-Channel was the strongest for each loading scenario. The FRP wrap method was the strongest under axial loading; it lacked in bending capacity compared to other methods. Bending failure in FRP splicing mechanism occurred due to the lack of adequate fiber reinforcement in the hoop direction of the timber pile. To improve the bending and shear capacity of FRP spliced pile along the hoop direction, a six-layer fabric architecture was adopted, which showed significant improvement in bending and shear capacities from the original three-layer glass FRP composite wrap design. Even though the bending failure capacity of FRP wrapped composite with six layers is slightly lower (~15%) than the bending capacity of pile repaired with traditional splice mechanisms, axial and shear capacities of FRP spliced system were higher than those from traditional methods. With increases in the number of wrap layers and FRP fabric density, even bending capacity can be improved, and the deformation is far less than the deformation of wood piles with traditional splice mechanisms.
Zitieren
APA
Hota, G., Gopu, V. K., Damich, D., Alaywan, W., & Zhang, C. (2026). Timber Bridge Pile Splicing with Traditional and Fiber Reinforced Polymer Wrap Methods. International Journal of Bridge Engineering, Management and Research, 3(2). https://doi.org/10.70465/ber.v3i2.82
Vancouver
Hota G, Gopu VK, Damich D, Alaywan W, Zhang C. Timber Bridge Pile Splicing with Traditional and Fiber Reinforced Polymer Wrap Methods. International Journal of Bridge Engineering, Management and Research. 2026;3(2). doi:10.70465/ber.v3i2.82
BibTeX
@article{Hota2026,
author = {Hota, GangaRao and Gopu, Vijaya K.A. and Damich, Drew and Alaywan, Walid and Zhang, CHAO},
title = {Timber Bridge Pile Splicing with Traditional and Fiber Reinforced Polymer Wrap Methods},
journal = {International Journal of Bridge Engineering, Management and Research},
year = {2026},
volume = {3},
number = {2},
doi = {10.70465/ber.v3i2.82}
}
EUVIMED