EUVIMEDEUVIMED entdecken
Open Access · CC BY-SA 4.0

Perancangan Jig pada Pengujian Microscope Part Cylinder Comp untuk Meminimasi Cost Dengan Metode Dfma pada Industri Otomotif Kendaraan Bermotor Roda Dua

Karina Rahmadini, Renty Anugerah, Umi Marfuah, Ariya Purnamasari Dewi

Jurnal Cakrawala Akademika · 22.04.2026 · 2 (5) · 714-730

DOI: 10.70182/jca.v2i5.1754 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Jurnal Cakrawala Akademika, online erschienen am 22.04.2026. Verfasst von Karina Rahmadini und 3 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-SA 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study addresses the high cost and long duration of destructive cross hatch testing on cylinder comp parts in an automotive laboratory. The purpose is to design a micrometer jig that enables non destructive testing while reducing time and operational cost. This research used an explanatory design development approach with quantitative methods and R&D stages, supported by DFMA and TRIZ. The population covered the entire destructive testing process, while the sample consisted of cylinder comp parts type 100 cc, 125 cc, and 160 cc observed across three shifts. Data were collected through observation, semi structured interviews, time measurement, and cost recording, then analyzed descriptively and comparatively. The results show that the proposed jig changed the testing method from destructive to non destructive, reduced testing time from 778 minutes to 133 minutes, and lowered annual operating cost to Rp 59,563,161. In conclusion, the jig is technically feasible and economically effective for improving efficiency and preserving component integrity.

Zitieren

APA

Rahmadini, K., Anugerah, R., Marfuah, U., & Dewi, A. P. (2026). Perancangan Jig pada Pengujian Microscope Part Cylinder Comp untuk Meminimasi Cost Dengan Metode Dfma pada Industri Otomotif Kendaraan Bermotor Roda Dua. Jurnal Cakrawala Akademika, 2(5), 714-730. https://doi.org/10.70182/jca.v2i5.1754

Vancouver

Rahmadini K, Anugerah R, Marfuah U, Dewi AP. Perancangan Jig pada Pengujian Microscope Part Cylinder Comp untuk Meminimasi Cost Dengan Metode Dfma pada Industri Otomotif Kendaraan Bermotor Roda Dua. Jurnal Cakrawala Akademika. 2026;2(5):714-730. doi:10.70182/jca.v2i5.1754

BibTeX
@article{Rahmadini2026,
  author = {Rahmadini, Karina and Anugerah, Renty and Marfuah, Umi and Dewi, Ariya Purnamasari},
  title = {Perancangan Jig pada Pengujian Microscope Part Cylinder Comp untuk Meminimasi Cost Dengan Metode Dfma pada Industri Otomotif Kendaraan Bermotor Roda Dua},
  journal = {Jurnal Cakrawala Akademika},
  year = {2026},
  volume = {2},
  number = {5},
  pages = {714--730},
  doi = {10.70182/jca.v2i5.1754}
}
Kostenlos starten →