Evaluation of the potential and mitigation strategies of post-liquefaction residual deformations in heterogeneous fill soils through performance-based parametric simulations
Derbyana · 16.11.2026 · 47
DOI: 10.69469/derb.v47.920 ↗Kurz gefasst
Fachartikel in der Zeitschrift Derbyana, online erschienen am 16.11.2026. Verfasst von Erfandi Rahman und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Assessments of liquefaction hazards in heterogeneous reclaimed soils are often limited to safety factor-based triggering analyses (FSliq) without considering the consequences of post-earthquake residual deformation. This study aims to evaluate the reliability of FSliq as a single indicator for representing permanent deformation response, as well as to determine the optimal performance-based design threshold for soil improvement. The analysis is based on ten CPTu soundings reported in previous study from the Pantai Indah Kapuk land reclamation area, North Jakarta, evaluated under the Cimandiri Fault earthquake scenario (Mw 6.7). Residual deformation estimates were calculated using semi-empirical vertical and horizontal approaches. The results of the baseline analysis indicate significant vulnerability in the 4.0–10.5 m layer, where FSliq < 1.0, which could trigger vertical settlement of up to 26.02 cm and lateral displacement of up to 300.52 cm. Parametric simulations of three remediation scenarios (light, moderate, and intensive) detected fluctuations in negative Deformation Reduction Ratio (DRR) values at local 0.5-meter intervals in Scenario 1 (light). This phenomenon was validated as a physical manifestation of the boundary sensitivity state, where minor reinforcement – which was insufficient to bring the FSliq value out of the critical zone (FSliq ≤ 0.5) – triggered a transient strain spike. The cumulative nonlinear regression plot of the entire profile clearly confirms the point of diminishing returns in engineering efficiency following Scenario 2 (Moderate). The moderate improvement target, with an average profile strength of qc ~ 13.85 MPa is considered the most recommended design criterion because it effectively limits deformation to safe allowable limits with DRRSett ≈ 80.24% and DRRLD ≈ 88.80% without requiring a high level of construction energy waste in Scenario 3.
Zitieren
APA
Rahman, E., Azikin, B., & Pachri, H. (2026). Evaluation of the potential and mitigation strategies of post-liquefaction residual deformations in heterogeneous fill soils through performance-based parametric simulations. Derbyana, 47. https://doi.org/10.69469/derb.v47.920
Vancouver
Rahman E, Azikin B, Pachri H. Evaluation of the potential and mitigation strategies of post-liquefaction residual deformations in heterogeneous fill soils through performance-based parametric simulations. Derbyana. 2026;47. doi:10.69469/derb.v47.920
BibTeX
@article{Rahman2026,
author = {Rahman, Erfandi and Azikin, Busthan and Pachri, Hendra},
title = {Evaluation of the potential and mitigation strategies of post-liquefaction residual deformations in heterogeneous fill soils through performance-based parametric simulations},
journal = {Derbyana},
year = {2026},
volume = {47},
doi = {10.69469/derb.v47.920}
}
EUVIMED