EUVIMEDEUVIMED entdecken
Crossref

A Low-Cost 3D-Printed Task Trainer for Pediatric Otic & Nasal Foreign Body Removal

Lith Nasif, Anna Henricks, Elizabeth Harvey, Kirk Atkinson, Ngoc Van Horn

Simulation Technology & Operations Resource Magazine · 2026

DOI: 10.68645/454769 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Simulation Technology & Operations Resource Magazine, 2026. Verfasst von Lith Nasif und 4 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Introduction

Nasal and otic foreign bodies are common in pediatric practice, but most trainees have limited procedural experience because of inconsistent patient availability and safety concerns. Commercial task trainers are often expensive or lack pediatric anatomical realism. Lowcost 3D printing offers an accessible alternative; however, there are few published models that address foreign body removal. This activity used a 3D-printed pediatric head to determine whether a low-cost task trainer could improve learner comfort and knowledge with foreign body removal.

Methods

Participants included 28 incoming pediatric interns at a large academic medical center. Learners completed a pre-simulation survey that gauged experience, comfort, and procedural knowledge. Trained pediatric residents facilitated learners through otic and nasal foreign body removal using otoscopes, alligator forceps, hooks, and Katz extractors on a 3D-printed task trainer. After practice, participants completed a post-simulation survey assessing comfort and knowledge. Knowledge improvement was measured using a multiple-choice quiz; comfort was measured using a Likert scale. Paired t-tests were used to determine significance between pre- and post-simulation knowledge scores and comfort.

Results

At baseline, 64% of participants reported no prior exposure to foreign body removal, and 60% indicating they were “not comfortable at all.” Knowledge scores improved from 48% pre-simulation to 95% post-simulation (p < 0.001). Similarly, comfort improved significantly, with 65% of participants reporting readiness to perform the procedure with minimal assistance (p < 0.01).

Conclusion

This low-cost 3D-printed task trainer is an effective method of enhancing learner confidence and procedural knowledge. Its affordability and reproducibility support broad implementation, particularly in resource-limited educational settings.

Zitieren

APA

Nasif, L., Henricks, A., Harvey, E., Atkinson, K., & Horn, N. V. (2026). A Low-Cost 3D-Printed Task Trainer for Pediatric Otic & Nasal Foreign Body Removal. Simulation Technology & Operations Resource Magazine. https://doi.org/10.68645/454769

Vancouver

Nasif L, Henricks A, Harvey E, Atkinson K, Horn NV. A Low-Cost 3D-Printed Task Trainer for Pediatric Otic & Nasal Foreign Body Removal. Simulation Technology & Operations Resource Magazine. 2026. doi:10.68645/454769

BibTeX
@article{Nasif2026,
  author = {Nasif, Lith and Henricks, Anna and Harvey, Elizabeth and Atkinson, Kirk and Horn, Ngoc Van},
  title = {A Low-Cost 3D-Printed Task Trainer for Pediatric Otic & Nasal Foreign Body Removal},
  journal = {Simulation Technology & Operations Resource Magazine},
  year = {2026},
  doi = {10.68645/454769}
}
Kostenlos starten →